The Effect of Disc Surface Topography on the Dry Gross Fretting Wear of an Equal-Hardness Steel Pair
Open Access
Abstract
Experimental investigations were carried out with an Optimol SRV5 tribological tester in a flat-on-sphere scheme. The balls co-acted with the discs in a gross sliding fretting regime. The balls and discs were made from the same steel with a very similar hardness. Tests were conducted at 25–35% relative humidity, 30 °C, and a constant normal load and number of cycles (18,000). The discs had different textures after various machining treatments. It was found that the total wear level of the tribological assembly was proportional to the disc surface amplitude. The influence of the disc roughness on the coefficient of friction was evident only for the smallest stroke of 0.1 mm, and the frequency of oscillation affected this dependency.Keywords
This publication has 48 references indexed in Scilit:
- Towards a unified classification of wearFriction, 2013
- Application of an energy wear approach to quantify fretting contact durability: Introduction of a wear energy capacity conceptTribology International, 2007
- A finite element based approach to simulating the effects of debris on fretting wearWear, 2007
- Progress in fretting mapsTribology International, 2006
- Theoretical Substantiation of the Slip Index Approach to FrettingTribology Letters, 2005
- Slip Index: A New Unified Approach to FrettingTribology Letters, 2004
- Different aspects of the role of wear debris in fretting wearWear, 2002
- Analysis of sliding behaviour for fretting loadings: determination of transition criteriaWear, 1995
- The role of oxide particles in the fretting wear of mild steelWear, 1991
- On fretting mapsWear, 1988