Finite Element Simulation and Experimental Investigation of Nanostructuring Burnishing AISI 52100 Steel Using an Inclined Flat Cylindrical Tool
Open Access
- 24 April 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (9) , 5324
Abstract
This article is devoted to the development of a sliding burnishing scheme using a flat cylindrical indenter. The previously established patterns of nanostructured state formation in the AISI 52100 steel subsurface layer showed a need to create a special tool with a variable tilt angle of the indenter and with force regulation. A new tool with a cubic boron nitride indenter opens wide possibilities for nanostructuring burnishing of hardened bearing steel. Firstly, a flat cylindrical indenter has high durability due to repeated rotation around its axis. Secondly, the change of the tilt angle to the treated surface allows controlling the contact compression pressure and plastic shear deformation, which determines the formation of a nanostructured state of the material by the method of severe plastic deformation (SPD). The purpose of the work is to determine the optimal parameters of the process and tool in order to form a nanostructure and significantly increase surface layer microhardness. The goal was achieved by the methods of finite element modeling (FEM) and experimental studies of burnishing when the indenter tilt angle changes from 0.5° to 2.5° under dry processing conditions. Numerical simulation of the process made it possible to establish optimal values of the indenter tilt angle of 2° and the burnishing force 250 N according to the criteria of maximum contact pressure and cumulative deformation. The experimental studies of cumulative deformations and the coefficient of friction by the method of burnishing a split disc and dynamometry of the process confirmed the FEM results. The transmission microscopy, durometry, and 3D surface profilometry showed the sensitivity of nanocrystallite sizes, microhardness, and roughness to an indenter tilt angle and confirmed the optimality of the established tilt angle value.Keywords
Funding Information
- Ministry of Science and Higher Education of the Russian Federation (FWRW-2022-0003)
- government research (FWRW-2022-0003)
This publication has 22 references indexed in Scilit:
- Numerical simulation of grinding induced phase transformation and residual stresses in AISI-52100 steelFinite Elements in Analysis and Design, 2012
- Determination of Johnson–Cook parameters from machining simulationsComputational Materials Science, 2012
- Surface layer characteristics due to slide diamond burnishing with a cylindrical-ended toolJournal of Materials Processing Technology, 2011
- Modeling of white layer formation under thermally dominant conditions in orthogonal machining of hardened AISI 52100 steelInternational Journal of Machine Tools and Manufacture, 2008
- Study of the mechanism of the burnishing process with cylindrical polycrystalline diamond toolsJournal of Materials Processing Technology, 2006
- Producing bulk ultrafine-grained materials by severe plastic deformationJOM, 2006
- Dynamic Material Behavior Modeling Using Internal State Variable Plasticity and Its Application in Hard Machining SimulationsJournal of Manufacturing Science and Engineering, 2005
- Finite Element Modeling of Roller Burnishing ProcessCIRP Annals, 2005
- Mechanical Properties of Hardened AISI 52100 Steel in Hard Machining ProcessesJournal of Manufacturing Science and Engineering, 2001
- On modelling the influence of thermo-mechanical behavior in chip formation during hard turning of 100Cr6 bearing steelCIRP Annals, 2001