A Review of Recent Research on Flow and Heat Transfer Analysis in Additively Manufactured Transpiration Cooling for Gas Turbines
Top Cited Papers
Open Access
Abstract
Advanced gas turbine cooling technologies are required to bridge the gap between turbine inlet temperatures and component thermal limits. Transpiration cooling has emerged as a promising method, leveraging porous structures to enhance cooling effectiveness. Recent advancements in additive manufacturing (AM) enable precise fabrication of complex transpiration cooling architectures, such as triply periodic minimal surface (TPMS) and biomimetic designs. This review analyzes AM-enabled transpiration cooling for gas turbines, elucidating key parameters, heat transfer mechanisms, and flow characteristics of AM-fabricated designs through experimental and numerical studies. Previous research has concluded that well-designed transpiration cooling achieves cooling effectiveness up to five times higher than the traditional film cooling methods, minimizes jet lift-off, improves temperature uniformity, and reduces coolant requirements. Optimized coolant controls, graded porosity designs, complex topologies, and hybrid cooling architectures further enhance the flow uniformity and cooling effectiveness in AM transpiration cooling. However, challenges remain, including 4–77% porosity shrinkage in perforated transpiration cooling for 0.5–0.06 mm holes, 15% permeability loss from defects, and 10% strength reduction in AM models. Emerging solutions include experimental validations using advanced diagnostics, high-fidelity multiphysics simulations, AI-driven and topology optimizations, and novel AM techniques, which aim at revolutionizing transpiration cooling for next-generation gas turbines operating under extreme conditions.Keywords
Funding Information
- National Science and Technology Major Project (2017-III-0009-0035, 24Z033103800, 11972230, GZ1577)
- National Natural Science Foundation of China (2017-III-0009-0035, 24Z033103800, 11972230, GZ1577)
- Chinese-German Joint Cooperation Group (2017-III-0009-0035, 24Z033103800, 11972230, GZ1577)
This publication has 138 references indexed in Scilit:
- An Analysis Framework of Additively Manufactured Deterministic Porous Structures for Transpiration CoolingJournal of Materials Engineering and Performance, 2023
- Strut and sheet metal lattices produced via AM-assisted casting and powder bed fusion: A comparative studyAdditive Manufacturing Letters, 2022
- Flow and heat transfer studies of multijet impingement cooling for different configurations: A reviewHeat Transfer, 2022
- Additive manufacturing assisted investment casting: A low-cost method to fabricate periodic metallic cellular latticesAdditive Manufacturing, 2020
- Influence of aging and HIP treatment on the structure and properties of NiAl-based turbine blades manufactured by laser powder bed fusionAdditive Manufacturing, 2020
- Large-eddy simulation of transpiration cooling in turbulent channel with porous wallApplied Thermal Engineering, 2018
- Experimental investigation of full-coverage effusion cooling through perforated flat platesApplied Thermal Engineering, 2015
- Porous Ceramic Coating for Transpiration Cooling of Gas Turbine BladeJournal of Thermal Spray Technology, 2013
- 316L Stainless Steel with Gradient Porosity Fabricated by Selective Laser MeltingJournal of Materials Engineering and Performance, 2009
- A two-phase mixture model of liquid-gas flow and heat transfer in capillary porous media—I. FormulationInternational Journal of Heat and Mass Transfer, 1993