Effects of post-weld heat treatment on the microstructural evolution and mechanical properties of dissimilar friction stir welded AA6061+SiCp/AA6061-O joint
Open Access
- 23 July 2018
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 15 (8)
Abstract
A research on the microstructure and mechanical properties of the dissimilar joint was carried out so as to understand the effects of post-weld heat treatment (PWHT) on microstructural evolution, microhardness, tensile and flexural properties of the dissimilar friction stir welded (FSWed) joint. The results showed that there is a sufficient and rather complicated material mixing in the nugget zone (NZ). After PWHT, the grains in the joint area except for the NZ demonstrated a grain refinement with more homogeneous and equiaxed grains. Fine and clustered SiC particles in the NZ are confirmed by scanning electron microscope (SEM). In addition, the microhardness values of nugget zones both in as-welded and PWHT condition exhibited a higher Vickers compared to that of AA6061-O. Furthermore, a mean tensile strength of 183.30 MPa that demonstrates a 52.22% increase in tensile strength is also observed in the transverse tensile tests subsequent to PWHT. Considering the three-point bending test results, it is explicit that an increase of 121.96% in the bending extension is obtained as there is no significant increase in maximum bending force after the PWHT.Keywords
This publication has 41 references indexed in Scilit:
- Effect of a post-weld heat treatment on the mechanical and microstructure properties of AA6061 joints welded by the gas metal arc welding cold metal transfer methodMaterials & Design (1980-2015), 2011
- Microstructures of dissimilar friction stir welded joints between 2024-T4 aluminum alloy and Al/Mg2Si metal matrix cast compositeComposites Part B: Engineering, 2011
- Effect of microstructural evolution on mechanical properties of friction stir welded AA2009/SiCp compositeComposites Science and Technology, 2008
- Effect of Tool Pin Profile and Tool Rotational Speed on Mechanical Properties of Friction Stir Welded AA6061 Aluminium AlloyMaterials and Manufacturing Processes, 2008
- Thermoelasticity for the evaluation of fatigue behavior of 7005/Al2O3/10p metal matrix composite sheets joined by FSWInternational Journal of Fatigue, 2008
- Effect of friction stir welding on microstructure, tensile and fatigue properties of the AA7005/10 vol.%Al2O3 compositeComposites Science and Technology, 2007
- Microstructures and wear property of friction stir welded AZ91 Mg/SiC particle reinforced compositeComposites Science and Technology, 2006
- Friction stir welding of an AA6061/Al2O3/20p reinforced alloyComposites Science and Technology, 2006
- An analytical model for the heat generation in friction stir weldingModelling and Simulation in Materials Science and Engineering, 2003
- Finite element modeling of friction stir welding—thermal and thermomechanical analysisInternational Journal of Machine Tools and Manufacture, 2003