A minimally invasive ultrasound probe using non-coax cabling
Authors:
- J. MuellerJMJ. Mueller
- D. DietzDDD. Dietz
- J. KuhnkeJKJ. Kuhnke
- 14 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 1011-1016
Abstract
The electrical and acoustical performance of ultrasonic transducers is critically dependent on the characteristics of the cable to which they are attached. The traditional solution for medical ultrasound probes is to use coaxial cables. However, as the number of elements increases and as size and weight requirements become of more concern, the pressure for cabling solutions that are smaller, lighter, and less expensive also continues to increase. One solution is to use non-coaxial ribbon cables that have been designed to minimize crosstalk and provide higher signal density and better ergonomics. Minimally-invasive ultrasound probes are a natural place for early adoption of this kind of nontraditional cable since laparoscopic, endoscopic, and catheter probes have exceptionally difficult space constraints. This paper describes the use of IMAGIN/sup TM/ probe cable and MICROFLAT/sup TM/ ribbon cable, products developed by the W.L. Gore company, for a wiring harness of an ultrasound laparoscope containing a 128 element array. Small coaxial cables physically fit but are very difficult to terminate.Keywords
This publication has 7 references indexed in Scilit:
- Adaptive imaging in the breast2003
- Electrical characteristics of ribbon-based probe cables2003
- Update of two dimensional arrays for real time volumetric and real time intracardiac imaging2003
- Catheter arrays: can intravascular ultrasound make a difference in managing coronary artery disease2002
- Laparoscopic ultrasound for minimally invasive surgery2002
- Crosstalk in ribbon-based probe cables2002
- Elevation performance of 1.25D and 1.5D transducer arraysIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1997