Effect of tool vibration on chip formation and cutting forces in the machining of fiber-reinforced polymer composites
Authors:
- 2 April 2016
- journal article
- research article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 20 (2) , 312-329
Abstract
This article investigates the chip formation mechanism and its influence on cutting forces during the elliptic vibration-assisted (EVA) cutting of fiber-reinforced polymer composites. To clarify the effect of the vibration, systematic finite element and experimental studies were performed on both the EVA and the traditional cutting of unidirectional fiber-reinforced polymers with various fiber orientations. The key factors that govern the cutting forces have been taken into account, such as the depth of cut, feed rate, tool vibration frequency and amplitude. The study found that fiber orientation significantly affects the chip formation and cutting forces. Fiber fracture can happen either above or below the trimming path, but that above the path dominates chip formation. When a fiber orientation is less than 90°, chipping is mainly through bending-induced fracture of fibers; when it is beyond 90°, however, chipping is mostly by crushing the fracture of fibers. Compared with a traditional cutting process, the EVA cutting can minimize the fiber orientation effect through localized fiber fracture. A dimensional analysis was then performed to provide a quantitative prediction of the cutting forces.Keywords
This publication has 28 references indexed in Scilit:
- Experimental Design for Engineering Dimensional AnalysisTechnometrics, 2013
- Modeling of machining of composite materials: A reviewInternational Journal of Machine Tools and Manufacture, 2012
- A study of abrasive water jet machining process on glass/epoxy composite laminateJournal of Materials Processing Technology, 2009
- Effect of dynamic response and displacement/stress amplitude on ultrasonic vibration cuttingJournal of Materials Processing Technology, 2009
- Polishing of polycrystalline diamond by the technique of dynamic friction—Part 5: Quantitative analysis of material removalInternational Journal of Machine Tools and Manufacture, 2009
- A review of the cutting of composite materialsProceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, 2003
- Analysis and prediction of laser cutting parameters of fibre reinforced plastics (FRP) composite materialsInternational Journal of Machine Tools and Manufacture, 2002
- Chip formation in orthogonal trimming of graphite/epoxy compositeComposites Part A: Applied Science and Manufacturing, 1996
- A failure analysis of water jet drilling in composite laminatesInternational Journal of Machine Tools and Manufacture, 1990
- A Theory of Machining of Fiber-Reinforced MaterialsJournal of Composite Materials, 1971