Impact of Equal Channel Angular Pressing on Mechanical Behavior and Corrosion Resistance of Hot-Rolled Ti-2Fe-0.1B Alloy
Open Access
- 13 November 2020
- Vol. 13 (22) , 5117
Abstract
In the present study, the unique bimodal grain size distribution microstructure with the ultrafine substrate and embedded macro grains was fabricated by a traditional hot-rolling process in a novel low-cost Ti-2Fe-0.1B titanium alloy, which possesses a good combination of strength (around 663 MPa) and ductility (around 30%) without any post heat treatment. Meanwhile, the mechanical behavior and corrosion resistance of hot-rolled Ti-2Fe-0.1B alloy after equal channel angular pressing (ECAP) deformation were studied. Results indicated that the average grain size decreased to 0.24 μm after 4 passes ECAP deformation, which led to the enhancement of tensile strength to around 854 MPa and good ductility to around 15%. In addition, corrosion resistance was also improved after ECAP due to the rapid self-repairing and thicker passivation film. Our study revealed that the novel low-cost titanium alloy after hot-rolling and ECAP could be used instead of Ti-6Al-4V in some industrial applications due to similar mechanical behavior and better corrosion resistance.Keywords
Funding Information
- National Natural Science Foundation of China (No.51931008)
- The Russian Science Foundation in the framework of the project (No.20-63-47027)
- State Key Laboratory Open Source for Metal Materials and Applications for Marine Equipment (No.SKLMEA-K201807)
- The financial assistance from the China Postdoctoral Science Foundation (No.2017M623392)
This publication has 32 references indexed in Scilit:
- Service properties of ultrafine-grained Ti–6Al–4V alloy at elevated temperatureJournal of Materials Science, 2013
- The effect of shot peening on the microstructure and properties of a near-alpha titanium alloy following high temperature exposureActa Materialia, 2012
- Deformation behaviour of commercially pure titanium at extreme strain ratesActa Materialia, 2011
- Enhanced Strength and Ductility of Ultrafine‐Grained Ti Processed by Severe Plastic DeformationAdvanced Engineering Materials, 2010
- Effects of Fe addition on tensile deformation mode and crevice corrosion resistance in Ti–15Mo alloyMaterials Science and Engineering: A, 2010
- ECAP of commercially pure titanium: A reviewTransactions of the Indian Institute of Metals, 2008
- Evaluation of cast Ti–Fe–O–N alloys for dental applicationsMaterials Science and Engineering: C, 2005
- Stress-induced phase transformation during superplastic deformation in two-phase Ti–Al–Fe alloyActa Materialia, 2000
- Study of the corrosion behavior of titanium and some of its alloys for biomedical and dental implant applicationsJournal of Electroanalytical Chemistry, 1999
- The effect of iron and three interstitial elements on the stress corrosion cracking of titanium in sea waterCorrosion Science, 1995