Computer Interactive JIc of Testing Navy Alloys
Authors:
- 1 January 1979
- book chapter
- Published by ASTM International
- p. 451-468
Abstract
A computer interactive unloading compliance single-specimen JIc test procedure has been developed. This procedure utilizes an on-line minicomputer to analyze digitized load-displacement data during testing. Unique values of JI and crack length are determined from compliance measurement on short unloadings along the load displacement record. The test procedure is presented in detail and analysis procedures are discussed. Three tasks which demonstrate the validity and utility of the computer interactive test method are discussed. Results for single-specimen and multiple-specimen tests are presented for HY 130, 10Ni steel, 17-4PH steel, Ti-7Al-2Cb-1Ta, and Ti-6Al-4V which show close correspondence between the two methods. Tests on 17-4PH steel compact tension specimens with various thicknesses and crack lengths are summarized and dimensional effects on JIc and the J-Δa resistance curve slopes are discussed. Finally, tests on HY 130 specimens with various notch root radii demonstrate effects of notch acuity on JIc.Keywords
This publication has 8 references indexed in Scilit:
- Review and extension of compliance information for common crack growth specimensInternational Journal of Fracture, 1978
- Upper shelf temperature dependence of fracture toughness for four low to intermediate strength ferritic steelsEngineering Fracture Mechanics, 1977
- A J Integral Analysis for the Compact Specimen, Considering Axial Force as Well as Bending EffectsJournal of Pressure Vessel Technology, 1974
- A Path Independent Integral and the Approximate Analysis of Strain Concentration by Notches and CracksJournal of Applied Mechanics, 1968
- Singular behaviour at the end of a tensile crack in a hardening materialJournal of the Mechanics and Physics of Solids, 1968
- Plane strain deformation near a crack tip in a power-law hardening materialJournal of the Mechanics and Physics of Solids, 1968
- Analysis of Stresses and Strains Near the End of a Crack Traversing a PlateJournal of Applied Mechanics, 1957
- On the Stress Distribution at the Base of a Stationary CrackJournal of Applied Mechanics, 1957