AN ANALYSIS OF SURFACE CRACKING DURING ORTHOGONAL MACHINING OF GLASS
Authors:
- 31 July 2001
- journal article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 5 (2) , 195-215
Abstract
It has been proposed that a rough–semi-finish–finish strategy may be possible in the machining of glass and other brittle materials to achieve higher productivity than is realized through either grinding or ductile-mode machining, both of which have been studied extensively to date. A previously presented experimental study of orthogonal glass cutting exhibited clear transitions in machining modes as the uncut chip thickness is increased. One of those modes involves ductile-mode chip formation combined with surface damage in the form of surface cracks that protrude down into the machined surface and ahead of the cutting edge. Here, a model is formulated and exercised to better understand this surface-cracking damage. The finite element method is used with a custom written re-meshing subroutine employed under a commercial software package. The analysis focuses on the crack depth and lead (ahead of the tool) as a function of the normalized process force and the fracture toughness of the work material. It is found that load ratio, the ratio of the cutting (surface-tangential) force to the thrust (surface-normal) force, plays a significant role in the crack growth problem, as does the manner in which the thrust load is distributed relative to the cutting load. It is shown that point-wise application of the loads produces results far off from the experimental results, whereas distributed loads can produce results well aligned with the experiments. Given that ductile-mode chip formation occurs during surface cracking, the load distributions found to work well exhibit qualitatively the same characteristics that one would expect based on extending the well-known mechanics of metal cutting.Keywords
This publication has 12 references indexed in Scilit:
- AN EXPERIMENTAL STUDY OF ORTHOGONAL MACHINING OF GLASSMachining Science and Technology, 2000
- An analysis of Chipping in Brittle MaterialsInternational Journal of Fracture, 1998
- Brittle fracture under a sliding line contactJournal of the Mechanics and Physics of Solids, 1994
- Boundary element crack closure calculation of three-dimensional stress intensity factorsInternational Journal of Fracture, 1993
- Ductile-regime machining model for diamond turning of brittle materialsPrecision Engineering, 1991
- Sliding Microindentation Fracture of Brittle MaterialsTribology Transactions, 1991
- Ductile‐Regime Machining of Germanium and SiliconJournal of the American Ceramic Society, 1990
- On the machining of glassJournal of Materials Science, 1980
- The surface cracking of glassy polymers under a sliding spherical indenterJournal of Materials Science, 1976
- Partial cone crack formation in a brittle material loaded with a sliding spherical indenterProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1967