Comparison of the Microstructures and Mechanical Properties in the Overlapping Region of Low Carbon Steel Additive Bead Fabricated by WAAM and FSP
Authors:
- 16 January 2023
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 54 (3) , 869-895
Abstract
No abstract availableKeywords
This publication has 91 references indexed in Scilit:
- Influence of Quenching On-line on Properties of X70 Steel for Sour Service Seamless PipeEnergy Procedia, 2012
- Thermo-mechanical analysis of Wire and Arc Additive Layer Manufacturing process on large multi-layer partsComputational Materials Science, 2011
- Steel-Based Composites: Driving Forces and ClassificationsAnnual Review of Materials Research, 2010
- The mechanisms of the fcc–bcc martensitic transformation revealed by pole figuresActa Materialia, 2010
- Recrystallization mechanisms during friction stir welding/processing of aluminum alloysScripta Materialia, 2008
- Strain hardening behavior of a friction stir welded magnesium alloyScripta Materialia, 2007
- Heat treatment in two phase region and its effect on microstructure and mechanical strength after welding of a low carbon steelMaterials & Design (1980-2015), 2007
- Improvement of the work hardening rate of ultrafine grained steels through second phase particlesScripta Materialia, 2005
- The effect of post-weld heat-treatment on mechanical-properties and residual-stresses mapping in welded structural steelJournal of Materials Processing Technology, 1995
- The influence of grain size on the stored energy and mechanical properties of copperActa Metallurgica, 1958