Vertically Stacked, Flip-Chip Wide Bandgap MOSFET Co-Optimized for Reliability and Switching Performance
- 22 October 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 9 (4) , 3904-3915
Abstract
SiC wide bandgap semiconductors offer significant improvement in high voltage and high-temperature stability; however, their associated packaging often can impede electrical performance and reliability. In this study, a new flip-chip package, implementing a vertically oriented MOSFET was investigated to achieve co-optimized thermomechanical reliability with low parasitic inductance. The architecture improves upon wire-bonded packages by allowing for top side cooling and reduced power loop inductance. Herein, the design effects of solder material and diameter as well as pitch size and drain connector geometry on thermal cycling reliability of the device were investigated using finite element methods. Additionally, thermal resistance in association with parasitic inductance of varying drain connector architectures is compared, while utilizing symmetry to facilitate manufacturability. By considering the complex effects of geometry and material, the optimal architecture was selected and fabricated. When comparing to a prior flip-chip design effort, this simulation-based design optimization was able to improve the solder fatigue life up to 11 times, while reducing parasitic inductance by 30 times. Experimentally, the associated electrical performance of the novel device showed improved switching behavior in double-pulse testing of a half-bridge module, with nearly-negligible overshoot voltage on switching; where an equivalent discrete package exhibited ~100% overshoot, and ~24% inductance improvement at the module level.Keywords
Funding Information
- National Science Foundation (2014-00555-04)
- POETS Engineering Research Center
This publication has 24 references indexed in Scilit:
- Miniaturized Double Side Cooling Packaging for High Power 3 Phase SiC Inverter Module with Junction Temperature over 220°C2016
- Fatigue life models for SnAgCu and SnPb solder joints evaluated by experiments and simulation2003
- Reliability analysis for fine pitch BGA package2002
- Thermo-mechanical analysis of solder joint fatigue and creep in a flip chip on board package subjected to temperature cycling loading2002
- Solder joint reliability of a lead-less RF-transistor2002
- High-temperature electronics - a role for wide bandgap semiconductors?Proceedings of the IEEE, 2002
- Comparison of 6H-SiC, 3C-SiC, and Si for power devicesIEEE Transactions on Electron Devices, 1993
- Solder Creep-Fatigue Analysis by an Energy-Partitioning ApproachJournal of Electronic Packaging, 1992
- Integrated Matrix Creep: Application to Accelerated Testing and Lifetime Prediction1991
- Creep and Stress Relaxation in Solder Joints1991