A 0.6-V 0.33-mW 5.5-GHz Receiver Front-End Using Resonator Coupling Technique
Authors:
- 11 April 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 59 (6) , 1629-1638
Abstract
In this study, a low-power and low-voltage 5.5-GHz receiver front-end circuit is designed using a resonator coupling technique. An on-chip transformer combined with the parasitic capacitances from a low-noise amplifier (LNA), a mixer, and the transformer itself comprises two coupled resonators of the resonator coupling network (RCN). The RCN functions as a balun, and couples energy from the LNA to the mixer. Under the critical coupling condition, the RCN gives a maximal current gain at resonance frequencies, equivalent to the same level by an ideal transformer. The analysis shows that the current gain is quite tolerable to the coupling coefficient variation, an advantageous feature for on-chip transformer design. The technique is verified by the receiver front-end in 0.18-μm CMOS technology. The RCN possess a current gain as high as 12 dB at 5.5 GHz. The measured input return loss, conversion gain, and third-order intermodulation intercept point of the entire circuit are 16 dB, 17.4 dB, and -1.5 dBm, respectively. The noise figure is 7.8 dB at the IF frequency of 1 MHz. The power consumption is only 0.33 mW from a 0.6-V supply. The required local oscillator power is only -9.5 dBm. This receiver front-end successfully demonstrates the resonator coupling technique.Keywords
This publication has 24 references indexed in Scilit:
- A 1.94 to 2.55 GHz, 3.6 to 4.77 GHz Tunable CMOS VCO Based on Double-Tuned, Double-Driven Coupled ResonatorsIEEE Journal of Solid-State Circuits, 2009
- A low-power RF front-end for 2.5 GHz receivers2008
- A monolithic 5.9-GHz CMOS I/Q direct-down converter utilizing a quadrature coupler and transformer-coupled subharmonic mixersIEEE Microwave and Wireless Components Letters, 2006
- 2.4-GHz receiver for sensor applicationsIEEE Journal of Solid-State Circuits, 2005
- A fully monolithic 260-/spl mu/W, 1-GHz subthreshold low noise amplifierIEEE Microwave and Wireless Components Letters, 2005
- A 0.6-V 1.6-mW transformer-based 2.5-GHz downconversion mixer with +5.4-dB gain and -2.8-dBm IIP3 in 0.13-/spl mu/m CMOSIEEE Transactions on Microwave Theory and Techniques, 2005
- CMOS Low-Noise Amplifier Design Optimization TechniquesIEEE Transactions on Microwave Theory and Techniques, 2004
- Power-conscious design of wireless circuits and systemsProceedings of the IEEE, 2000
- Novel active differential phase splitters in RFIC for wireless applicationsIEEE Transactions on Microwave Theory and Techniques, 1998
- A 1.5-V, 1.5-GHz CMOS low noise amplifierIEEE Journal of Solid-State Circuits, 1997