Thermal spray coatings of Ni–10 wt-%Al composite powder synthesised by low energy mechanical milling
- 1 May 2009
- journal article
- Published by SAGE Publications in Surface Engineering
- Vol. 25 (4) , 276-283
Abstract
Ni–10 wt-%Al composite powders, as a self-bonding spray material, were prepared by low energy mechanical milling process and then sprayed by plasma and flame spray techniques. The phase identification, microstructure, hardness and adhesion strength of the coatings were investigated by X-ray diffraction, SEM, ASTM E384-99 and ASTM C633-01 respectively. The size and microstructure of powder particles are two important parameters for thermal spraying. Morphological and microstructural investigation of the Ni–10 wt-%Al powders showed that the powder particles after 23 h of milling time had the optimum properties with respect to their size and microstructure. X-ray diffraction patterns of powder particles included only the elemental Ni and Al peaks without any traces of oxides or intermetallics phases. Powder particles produced by mechanical milling had a fine lamellar structure consisting of pure Al and Ni layers. This structure encourages the Ni/Al exothermic reaction during flight in plasma spraying. The adhesive tests also showed that the plasma and flame failure were cohesive, that is, within the coating itself, because adhesive on steel in both coatings is much higher than cohesive.Keywords
This publication has 14 references indexed in Scilit:
- Production of nanocrystalline cermet thermal spray powders for wear resistant coatings by high-energy millingMaterials Science and Engineering: A, 2003
- Nanostructured coatingsMaterials Science and Engineering: A, 2002
- Effect of mechanical alloying on the solid state reaction processing of Ni-36.5 at.% Al alloyIntermetallics, 2002
- Aluminum coatings via kinetic spray with relatively large powder particlesSurface and Coatings Technology, 2002
- Theoretical study of the powder behavior of porous particles in a flame during plasma sprayingSurface and Coatings Technology, 2002
- Mechanical alloying and millingProgress in Materials Science, 2001
- The effect of spray parameters on the properties of high velocity oxy-fuel NiAl intermetallic coatingsSurface and Coatings Technology, 2000
- Synthesis and characterization of mechanically alloyed and shock-consolidated nanocrystalline NiAl intermetallicActa Materialia, 1999
- Reactive spraying of nickel-aluminide coatingsJournal of Thermal Spray Technology, 1997
- Structural changes during low energy ball milling in the Al-Ni systemJournal of Materials Science Letters, 1996