On the impact of the filler on the complex modulus of asphalt mixtures
Authors:
- 10 February 2017
- journal article
- research article
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 19 (5) , 1057-1071
Abstract
Mineral fillers have been used in asphalt mixtures from their very beginning. Rapidly, formulators observed that the filler could have a strong influence on the final mixture. Nowadays, mineral fillers are essentially characterised by their ability to stiffen the bitumen, leading to the development of the celebrated “Rigden air voids” RV (EN 1097-4), now the corner stone of the European specifications for fillers in asphalt mixtures. If the way the filler modifies the rheological properties of mastics is now well described, the relationship between mastic and mixture properties remains poorly understood. Therefore, this paper describes a systematic study on the impact of increasing filler contents on asphalt mixtures. Experimental results are presented for two very different asphalt mixture formulas, a regular semi-dense Asphalt Concrete (AC) and an open-graded AC for very thin layers (BBTM). The complex modulus of each formula was measured as a function of filler content with two materials having very different stiffening behaviour, that is, limestone filler (LF) and hydrated lime (HL). For both formulas and regardless of the type of filler, the modulus versus filler content curves exhibited a well-defined maximum. The filler content at which the maximum was found was strongly filler dependent, with HL formulas peaking at 4 wt.% and LF formulas peaking at 10 wt.%. An original interpretation based on reduced variables was proposed, showing that the maximum in modulus occurred for reduced volume fraction of filler close to 66%. This suggests that, before the peak, modulus increased with filler content as a consequence of a stiffer mastic, and after the peak, modulus started to decrease due to poor aggregate coating as a consequence of too-viscous a mastic. As a practical consequence, the studied mix formulas could accept higher filler loadings than currently specified, which would potentially stiffen the mixtures by ∼20%. Therefore, one way to benefit from these findings without changing the specifications would be to use blends of HL and LF. Of course, these findings must be validated with other mixture formulas and raw materials, and similar systematic study on the filler impact on the resistance to fatigue and moisture damage would be needed before implementing the conclusions based on modulus only.Keywords
This publication has 15 references indexed in Scilit:
- Determination of particle size, surface area, and shape of supplementary cementitious materials by different techniquesMaterials and Structures, 2014
- An empirical framework for determining asphalt mastic viscosity as a function of mineral filler concentrationConstruction and Building Materials, 2012
- Influence of Filler Fractional Voids on Mastic and Mixture PerformanceTransportation Research Record: Journal of the Transportation Research Board, 2012
- The colloidal structure of bitumen: Consequences on the rheology and on the mechanisms of bitumen modificationAdvances in Colloid and Interface Science, 2009
- The influence of aggregate, filler and bitumen on asphalt mixture moisture damageConstruction and Building Materials, 2008
- The structure of mineral fillers and their stiffening properties in filler-bitumen masticsMaterials and Structures, 2007
- Modelling asphalt mastic stiffness using discrete element analysis and micromechanics-based modelsInternational Journal of Pavement Engineering, 2005
- Rheometry of Pastes, Suspensions, and Granular Materials2005
- Linear viscoelastic behaviour of bituminous materials: From binders to mixesRoad Materials and Pavement Design, 2004
- Effect of Filler Type and Content on Properties of Asphalt Concrete Mixes1992