Two-Section Pulse Current Generator for Concrete and Rocks Destruction by Splitting Off
Authors:
- 18 October 2017
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 45 (11) , 3042-3045
Abstract
The relevance of electro-discharge technology usage for construction and demolition work in dense urban areas is discussed. The technical possibilities and the equipment based on a two-section pulse current generator for multiborehole electrodischarge splitting off and destruction of rocks and concrete are described. Ways to increase the efficiency of electro-discharge solid materials destruction method are proposed. To increase the effectiveness of the crack initiation, the high-current pulse should have a high rate of rising edge (practically well-founded 3-7 kA/μs). For crack propagation, the pulse duration should be as long as possible. (Good value is more than 500 μs.) Achievement of such controversial requirements in one generator is not a trivial task. To solve this contradiction and to increase the discharge circuit energy, the separation of the storage energy into two capacitor batteries as well as doubling the capacitance has been done. The inductance of 28 μH was installed in series with one battery section, which led to an increase in the channel energy release duration up to 400 μs. To increase the pulse duration even further, a pulse delay between two batteries was implemented. It is shown that in modes with a triggering pause between the batteries, the tensile stresses are formed earlier and covered almost all the distance from the borehole to the free border and acted on this space for a longer period of time.Keywords
Funding Information
- RFBR (16-48-700278)
This publication has 5 references indexed in Scilit:
- Fabrication and Testing of a 600-kJ Pulsed Power SystemIEEE Transactions on Plasma Science, 2013
- Theoretical and experimental investigation of electro discharge destruction of non-conducting materials2011
- Dynamics of electro burst in solids: I. Power characteristics of electro burstJournal of Physics D: Applied Physics, 2009
- Electrohydraulic Rock Blasting: An Alternative for Mining in Urban AreasInternational Journal of Surface Mining, Reclamation and Environment, 2002
- Application of pulsed HV discharges to material fragmentation and recyclingIEEE Transactions on Dielectrics and Electrical Insulation, 2000