Non-Penetrating Impact Behavior of CFRP at Low and Intermediate Velocities
Authors:
- 1 January 1995
- book chapter
- Published by ASTM International
- p. 333-350
Abstract
A series of instrumented impact tests have been carried out using two different CFRP laminates, IM6/937 with a relatively brittle matrix and T800H/3900-2 with a toughened matrix. Two impactor masses differing from each other by a factor of 20 were used to study the effect of impact velocity and rate of loading. Differences in the target impact response were found when the panels were impacted with the same energy but at different velocities. The higher velocities led consistently to slightly higher measured peak forces, but lower maximum deflections. This difference is reflected in the resultant damage state. The measured delamination area is larger for the high-mass impacts at the same incident impact energy, particularly for the tough matrix system. However, when the delamination size is correlated with the impactor energy loss, the mass effect disappears. The low-mass, high-velocity impacts create large contact forces, which leads to significant fiber breakage on the impact face. Fiber breakage throughout the rest of a panel is lower, which can be explained by the lower maximum panel deflections observed in low-mass impacts. An energy balance that takes into account the work done in delamination and fiber breakage gives good agreement with the measured impactor energy loss over the complete range of impact energies tested.Keywords
This publication has 16 references indexed in Scilit:
- The impact resistance of composite materials — a reviewComposites, 1991
- Impact on Laminated Composite MaterialsApplied Mechanics Reviews, 1991
- Impact behaviour and damage tolerance of woven carbon fibre-reinforced thermoplastic compositesComposites, 1990
- Impact perforation of carbon fibre reinforced plasticComposites Science and Technology, 1990
- Comparison of the low and high velocity impact response of cfrpComposites, 1989
- The influence of varying projectile mass on the impact response of CFRPComposite Structures, 1989
- Hygrothermal and Strain Rate Effects on Properties of Graphite/Epoxy CompositesJournal of Engineering Materials and Technology, 1988
- On Low-Velocity Impact Testing of Composite MaterialsJournal of Composite Materials, 1988
- The influence of target geometry on the high velocity impact response of CFRPComposite Structures, 1988
- Direct force measurement in normal and oblique impact of plates by projectilesInternational Journal of Impact Engineering, 1987