Soil-blade orientation effect on tillage forces determined by 3D finite element models
Authors:
Open Access
- 10 October 2014
- journal article
- Published by Instituto Nacional de Investigacion y Tecnologia Agraria y Alimentaria (INIA) in Spanish Journal of Agricultural Research
- Vol. 12 (4) , 941-951
Abstract
This paper investigated the effect of the cutting parameters of a blade on the tillage force components using finite element modeling. A three-dimensional model was carried out with Abaqus Explicit in order to study the interaction between the tool and soil. The soil was modeled with linear forms of the Drucker-Pager model, while the tool was considered as a rigid body with a reference point taken at its tip. The effect of tillage depth and the width of a vertical blade were studied. It was found that the amounts of the draught and vertical forces increase linearly with a slope of 0.037 and 0.0143 respectively when the width increases. The narrow tool (width< 60mm) has a greater effect on the specific draught force than a larger tool. Draught and specific draught force increase with polynomial and linear curve respectively versus the depth. However, this effect was reduced for the vertical force. These results were in a good agreement with previously published works. The second part of this paper is focused on the oblique position of the blade to evaluate the effect of the attack angles on both the tillage forces (draught, lateral and vertical) and the cutting process of the soil during and after its failure. For all considered angles, the draught force presents the highest values compared to the vertical and lateral forces. Results showed that working with small cutting and an average rake angles (30° to 60° and 45° respectively) can produce a good soil inversion.Keywords
This publication has 34 references indexed in Scilit:
- Finite element simulation of moldboard–soil interactionSoil and Tillage Research, 2013
- Strip tillage width effects on sunflower seed emergence and yieldSoil and Tillage Research, 2013
- A discrete element model for soil–sweep interaction in three different soilsSoil and Tillage Research, 2013
- Integrated soil tillage force prediction modelsJournal of Terramechanics, 2007
- SIMULATION OF SOIL DEFORMATION AROUND A TILLAGE TOOL USING COMPUTATIONAL FLUID DYNAMICSTransactions of the ASAE, 2005
- Simulation of soil–blade interaction for sandy soil using advanced 3D finite element analysisSoil and Tillage Research, 2004
- Finite Element Modelling of the Interaction of the Cutting Edge of Tillage Implements with SoilJournal of Agricultural Engineering Research, 1999
- Parametric study of a braced cut by finite element methodComputers and Geotechnics, 1998
- A non-linear 3-D finite element analysis of soil failure with tillage toolsJournal of Terramechanics, 1990
- An analytical model for predicting draft forces on convex-type wide cutting bladesSoil and Tillage Research, 1989