Effect of injection pressure on performance, emission, and combustion characteristics of diesel–acetylene-fuelled single cylinder stationary CI engine
- 30 December 2017
- journal article
- research article
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 25 (8) , 7767-7775
Abstract
In this paper, the effect of injection pressure on the performance, emission, and combustion characteristics of a diesel-acetylene fuelled single cylinder, four-stroke, direct injection (DI) diesel engine with a rated power of 3.5 kW at a rated speed of 1500 rpm was studied. Experiments were performed in dual-fuel mode at four different injection pressures of 180, 190, 200, and 210 bar with a flow rate of 120 LPH of acetylene and results were compared with that of baseline diesel operation. Experimental results showed that highest brake thermal efficiency of 27.57% was achieved at injection pressure of 200 bar for diesel-acetylene dual-fuel mode which was much higher than 23.32% obtained for baseline diesel. Carbon monoxide, hydrocarbon, and smoke emissions were also measured and found to be lower, while the NOx emissions were higher at 200 bar in dual fuel mode as compared to those in other injection pressures in dual fuel mode and also for baseline diesel mode. Peak cylinder pressure, net heat release rate, and rate of pressure rise were also calculated and were higher at 200 bar injection pressure in dual fuel mode.Keywords
This publication has 29 references indexed in Scilit:
- Diethyl ether as an ignition improver for acetylene-fuelled homogeneous charge compression ignition operation: an experimental investigationInternational Journal of Sustainable Energy, 2013
- An Experimental Investigation on the Effect of Injection Pressure on the Exhaust Emissions of a Diesel Engine Fueled with Methanol-diesel BlendsEnergy Sources, Part A: Recovery, Utilization, and Environmental Effects, 2011
- Experimental investigation of timed manifold injection of acetylene in direct injection diesel engine in dual fuel modeEnergy, 2010
- Effect of Injection Time and Injection Pressure on CI Engine Fuelled with Methyl Ester of Thevetia Peruviana Seed OilInternational Journal of Green Energy, 2010
- Experimental investigation on dual fuel operation of acetylene in a DI diesel engineFuel Processing Technology, 2010
- Experimental investigation of the effect of compression ratio and injection pressure in a direct injection diesel engine running on Jatropha methyl esterApplied Thermal Engineering, 2010
- Effect of injector opening pressures on the performance, emission and combustion characteristics of DI diesel engine running on honne oil and diesel fuel blendThermal Science, 2010
- Effect of injection pressure on heat release rate and emissions in CI engine using orange skin powder diesel solutionEnergy Conversion and Management, 2009
- An acetylene cylinder explosion: A most probable cause analysisEngineering Failure Analysis, 2006
- Evaluation of acetylene as a spark ignition engine fuelInternational Journal of Energy Research, 1979