Fiber orientation and mechanical properties of short‐fiber‐reinforced injection‐molded composites: Simulated and experimental results
Authors:
- 1 October 1993
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 14 (5) , 367-382
Abstract
A numerical simulation is presented that combines the flow simulation during injection molding with an efficient algorithm for predicting the orientation of short fibers in thin composite parts. Fiber‐orientation state is represented in terms of a second‐order orientation tensor. Fiber‐fiber interactions are modeled by means of an isotropic rotary diffusion. The simulation predicts flow‐aligned fiber orientation (shell region)near the surface with transversely aligned (core region) fibers in the vicinity of the mid‐plane. The effects of part thickness and injection speed on fiber orientation are analyzed. Experimental measurements of fiber orientation in plaque‐shaped parts for three different combinations of cavity thickness and injection speed are reported. It is found that gapwise‐converging flow due to the growing layer of solidified polymer near the walls tends to flow‐align the fibers near the entrance, whereas near the melt front, gapwise‐diverging flow due to the diminishing solid layer tends to lign the fibers transverse to the flow. The effect of this gapwise‐converging‐diverging flow is found to be especially significant for thin parts molded at slower injection speeds, which have a proportionately thicker layer of solidified polymer during the filling process. If the fiber orientation is known, predictions of the anisotropic tensile moduli and thermal‐expansion coefficients of the composite are obtained by using the equations for unidirectional composites and taking an orientation average. These predictions are found to agree reasonably well with corresponding experimental measurements.Keywords
This publication has 28 references indexed in Scilit:
- Prediction of Fiber Orientation and Mechanical Properties in Short-Fiber Reinforced Injection-Molded Composites1992
- The motion of rodlike particles in the pressure-driven flow between two flat platesRheologica Acta, 1990
- Closure approximations for three‐dimensional structure tensorsJournal of Rheology, 1990
- Injection moulding of thermoplastics: Freezing during mould fillingRheologica Acta, 1983
- Non-isothermal flow of a molten polymer in a narrow rectangular cavityJournal of Non-Newtonian Fluid Mechanics, 1982
- Unsteady Slow Flows Over a Cooled Flat PlateIMA Journal of Applied Mathematics, 1982
- A finite-element/finite-difference simulation of the injection-molding filling processJournal of Non-Newtonian Fluid Mechanics, 1980
- Constitutive equations in suspension mechanics. Part 2. Approximate forms for a suspension of rigid particles affected by Brownian rotationsJournal of Fluid Mechanics, 1976
- The Elastic Moduli of Fiber-Reinforced MaterialsJournal of Applied Mechanics, 1964
- A theory of anisotropic fluidsJournal of Fluid Mechanics, 1962