Corrosion Behavior of Two-Phase Fe-Mn-Al Alloys in 3.5% NaCl Solution
Authors:
- S.T. ShihSSS.T. Shih
- C.Y. TaiCTC.Y. Tai
- 1 February 1993
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 49 (2) , 130-134
Abstract
Four two-phase Fe-Mn-Al alloys with nominal compositions Fe-24Mn-9Al (alloy A), Fe-30Mn-13Al (B), Fe-27Mn-9Al-3Cr (C), and Fe-27Mn-9Al-6Cr (D) were prepared. The fractions of ferrite were controlled at approximately 46 to 61%, mainly by adjusting the carbon content and the relative amounts of Mn and Al. Both potentiodynamic polarization and immersion tests in 3.5% NaCl solution were conducted to evaluate the corrosion resistance of these alloys. The effects of increase of Al or addition of Cr to the prototype alloy A were examined. The different corrosion behaviors of ferrite and austenite were compared. Polarization tests indicated that only a limited region of passivation was present for all alloys, and the corrosion resistances of these alloys were all inferior to those of commercial stainless steels. During the 110-day period of immersion test, pitting was the primary type of corrosion. General corrosion was not significant. The order of weight loss due to pitting corrosion for these alloys was A > B > C > D, with the maximum difference being approximately a factor of two. Microstructural examination showed that pitting took place preferentially through the ferrite grains. Austenite was more resistant to pitting irrespective of the compositions. Increase of Al content or addition of Cr was beneficial to the resistance, but to improve the corrosion resistance of Fe-Mn-Al alloys in NaCl solution, controlling the phase seemed more important than controlling the composition.Keywords
This publication has 11 references indexed in Scilit:
- Phase transformation in an Fe-9.0AI-29.5Mn-1.2Si alloyMetallurgical Transactions A, 1991
- Long-period stacking-fault structure of the needle-like phase in a duplex FeMnAlC alloyActa Metallurgica et Materialia, 1991
- Hydrogen compatibility of Femnal alloysMetallurgical Transactions A, 1991
- The formation of bcc phase during the solution treatment of duplex FeMnAlC alloysMaterials Research Bulletin, 1990
- The bcc to fcc transformation in FeMnAlC alloysScripta Metallurgica, 1989
- Electrochemical polarization and pitting behaviour of Fe-Al-Mn alloys in chloride solutionsJournal of Materials Science, 1987
- Processing and properties of FeMnAl alloysMaterials Science and Engineering, 1986
- Aqueous corrosion properties of austenitic Fe-8.7Al-29.7Mn-1.04C alloySurface and Coatings Technology, 1986
- A high-temperature oxidation-resistant Fe-Mn-Al-Si alloyOxidation of Metals, 1984
- Oxidation of iron-manganese-aluminum alloys at 850 and 1000 COxidation of Metals, 1982