Analytical model for steady flow through a finite channel with one porous wall with arbitrary variable suction or injection
Authors:
- 1 December 2014
- journal article
- conference paper
- Published by AIP Publishing in Physics of Fluids
- Vol. 26 (12) , 123603
Abstract
This paper presents an exact solution of two-dimensional laminar flow through a finite length channel with one porous wall. It improves upon previous solutions by (1) satisfying the no-slip boundary condition at the channel dead end, (2) adding a turbulent term to the porous wall boundary condition, (3) allowing for arbitrary variable suction or injection across the porous wall, and (4) model validation against new cryogenic liquid hydrogen and oxygen experimental data. Of particular interest in the current work is the modeling of cryogenic propellant flow through a porous liquid acquisition device (LAD) screen and channel inside a propellant tank. First, a detailed review of the literature is presented for previously attempted solutions to channel flow with one porous wall. Next, the governing equations, boundary conditions, and model assumptions are used to derive the analytical flow solution and present general model results for pressure and velocity fields within the channel. Then, the model solution is compared with horizontal LAD channel flow data in liquid oxygen as well as vertical LAD channel flow data in an inverted outflow configuration in liquid hydrogen. Model results are used to update the static cryogenic bubble point pressure model with a dynamic bubble point term which factors in enhanced convection and cooling at the screen during propellant outflow. Convective heat transfer at the LAD screen during outflow is also quantified by comparing model and data. The new analytical flow solution with the dynamic bubble point model is shown to compare well with available cryogenic experimental data.Keywords
This publication has 95 references indexed in Scilit:
- POROUS SCREEN APPLIED IN LIQUID ACQUISITION DEVICE CHANNEL AND CFD SIMULATION OF FLOW IN THE CHANNELJournal of Porous Media, 2012
- Exact solution to mass transfer in Berman flow: Application to concentration polarization combined with osmosis in crossflow membrane filtrationInternational Journal of Heat and Mass Transfer, 2010
- Analysis of Laminar Flow in a Channel with One Porous Bounding WallInternational Journal of Fluid Mechanics Research, 2010
- The effective thermal conductivity of wire screenInternational Journal of Heat and Mass Transfer, 2006
- Turbulent flow in a channel occupied by a porous layer considering the stress jump at the interfaceInternational Journal of Heat and Mass Transfer, 2003
- Influence of slip velocity at a membrane surface on ultrafiltration performance—II. Tube flow systemInternational Journal of Heat and Mass Transfer, 1979
- Influence of slip velocity at a membrane surface on ultrafiltration performance—I. Channel flow systemInternational Journal of Heat and Mass Transfer, 1979
- Theoretical Analysis of Laminar Pipe Flow in a Porous Wall CylinderJournal of Dynamic Systems, Measurement, and Control, 1971
- Laminar Flow in a Uniformly Porous TubeJournal of Applied Mechanics, 1962
- Laminar boundary-layer flow near separation with and without suctionPhilosophical Transactions of the Royal Society of London. Series A, Mathematical and Physical Sciences, 1960