Initial attachment of osteoblastic cells onto sol‐gel derived fluoridated hydroxyapatite coatings
- 17 July 2007
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 84A (3) , 769-776
Abstract
Initial cell attachment and spreading of anchorage‐dependent cells onto the material surface are crucial concerns for the development of more effective implants. In this study, MG63 cells were employed to investigate the initial cell response to sol‐gel derived fluoridated hydroxyapatite (FHA) coatings. Along with that, surface roughness, wettability, and protein adsorption were also characterized for those FHA coatings, respectively. It was observed that both the surface roughness and contact angle have a slight increase in response to the incorporation of more fluorine ions. All FHA coatings showed similar amount of adsorbed proteins (∼1.6 μg/cm2) upon testing in culture medium. Cell counting showed that no significant difference was observed for the amount of initially attached cells between HA and fluoridated HA coatings during the first 4 h culture. On the other hand, the well‐spread cell on all prepared coating surface indicates that the incorporated fluorine ions have no adverse effect on cell spreading process. Therefore, it was suggested from this study that the prepared fluoridated hydroxyapatite coatings have comparable bioactivity to that of pure hydroxyapatite coating, and these results are meaningful for further investigation for application of FHA coatings. © 2007 Wiley Periodicals, Inc. J Biomed Mater Res, 2008Keywords
This publication has 36 references indexed in Scilit:
- Evaluation of interfacial shear strength and residual stress of sol–gel derived fluoridated hydroxyapatite coatings on Ti6Al4V substratesEngineering Fracture Mechanics, 2007
- Stem cell attachment to layer-by-layer assembled TiO2 nanoparticle thin filmsBiomaterials, 2006
- The effect of fluoride contents in fluoridated hydroxyapatite on osteoblast behaviorActa Biomaterialia, 2006
- Thermal and chemical stability of fluorohydroxyapatite ceramics with different fluorine contentsBiomaterials, 2005
- Influence of fluorapatite on the properties of thermally sprayed hydroxyapatite coatingsBiomaterials, 2004
- Hydroxyapatite and fluor‐hydroxyapatite layered film on titanium processed by a sol–gel route for hard‐tissue implantsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2004
- Sol‐gel preparation and in vitro test of fluorapatite/hydroxyapatite filmsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2003
- Sol–gel derived fluoridated hydroxyapatite filmsMaterials Research Bulletin, 2003
- Fabrication of pure hydroxyapatite and fluoridated-hydroxyapatite coatings by electrocrystallisationMaterials Letters, 1994
- Osteoblasts on hydroxyapatite, alumina and bone surfaces in vitro; morphology during the first 2 h of attachmentBiomaterials, 1992