Aerothermal Impact of Stator-Rim Purge Flow and Rotor-Platform Film Cooling on a Transonic Turbine Stage
Authors:
- 11 January 2010
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 132 (2) , 021006
Abstract
The sealing of the stator-rotor gap and rotor-platform cooling are vital to the safe operation of the high-pressure turbine. Contrary to the experience in subsonic turbines, this paper demonstrates the potential to improve the efficiency in transonic turbines at certain rim seal rates. Two types of cooling techniques were investigated: purge gas ejected out of the cavity between the stator rim and the rotor disk, and cooling at the rotor-platform. The tests were carried out in a full annular stage fed by a compression tube at M2is=1.1, Re=1.1×106, and at temperature ratios reproducing engine conditions. The stator outlet was instrumented to allow the aerothermal characterization of the purge flow. The rotor blade was heavily instrumented with fast-response pressure sensors and double-layer thin film gauges. The tests are coupled with numerical calculations performed using the ONERA’s code ELSA. The results indicate that the stator-rotor interaction is significantly affected by the stator-rim seal, both in terms of heat transfer and pressure fluctuations. The flow exchange between the rotor disk cavity and the mainstream passage is mainly governed by the vane trailing edge shock patterns. The purge flow leads to the appearance of a large coherent vortex structure on the suction side of the blade, which enhances the overall heat transfer coefficient due to the blockage effect created. The impact of the platform cooling is observed to be restricted to the platform, with negligible effects on the blade suction side. The platform cooling results in a clear attenuation of pressure pulsations at some specific locations. The experimental and computational fluid dynamics results show an increase in the turbine performance compared with the no rim seal case. A detailed loss breakdown analysis helped to identify the shock loss as the major loss source. The presented results should help designers improve the protection of the rotor platform while minimizing the amount of coolant used.Keywords
This publication has 42 references indexed in Scilit:
- The Effect of Coolant Injection on the Endwall Flow of a High Pressure Turbine2006
- The Control of Shroud Leakage Loss by Reducing Circumferential Mixing2006
- Effect of the Hub Endwall Cavity Flow on the Flow-Field of a Transonic High-Pressure TurbineJournal of Turbomachinery, 2004
- Simulation of the Interaction of Labyrinth Seal Leakage Flow and Main Flow in an Axial Turbine2002
- Mainstream Aerodynamic Effects Due to Wheelspace Coolant Injection in a High-Pressure Turbine Stage: Part I—Aerodynamic Measurements in the Stationary FrameJournal of Turbomachinery, 2001
- Endwall Cavity Flow Effects on Gaspath Aerodynamics in an Axial Flow Turbine: Part I — Experimental and Numerical Investigation2000
- Flow Interaction From the Exit Cavity of an Axial Turbine Blade Row Labyrinth SealJournal of Turbomachinery, 2000
- A Combined Experimental and Numerical Investigation of the Flow in a Heated Rotor/Stator Cavity, With a Radial Inflow1999
- Thermal Details in a Rotor–Stator Cavity at Engine Conditions With a MainstreamJournal of Turbomachinery, 1992
- Aerodynamic aspects of the sealing of gas-turbine rotor-stator systemsInternational Journal of Heat and Fluid Flow, 1988