Assessment of the Length and Depth of Delamination-Type Defects Using Ultrasonic Guided Waves
Open Access
- 29 July 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (15) , 5236
Abstract
Fiber-reinforced composite laminates are being increasingly used in various engineering components in the sectors of aerospace and green energy. Due to impacts throughout the service life of the structure, matrix breakage and delaminations significantly altering the structural integrity of the laminate can occur. Hence, robust guided wave structural health monitoring systems are required to ensure continuous safety of engineering structures. In this paper, the ultrasonic method based on the analysis of A0 mode reflecting within the defected area has been proposed to extract the length and the depth of the delamination-type defect. The technique proposed in this study extracts the depth of the damage by analyzing the magnitude variations of direct A0 mode which are caused by the difference of wave velocities in the upper and lower sub-laminates. This results in an altering and frequency-dependent forward-scattered amplitude of direct A0 mode. Furthermore, the proposed approach uses previously obtained information about the depth of the defect, which allows for the determination of the phase velocities of A0 and S0 modes in the upper and lower sub-laminates. As a result, the accuracy of the damage length estimation is increased. The performance of the proposed method was proven with 2D and 3D numerical simulations and experiments on samples with artificial defects. The method validation results showed that the proposed method with some limitations is capable of extracting the length of delamination with an approximate error below 6%.Keywords
This publication has 33 references indexed in Scilit:
- Delamination detection in composites through guided wave field image processingComposites Science and Technology, 2011
- Delamination Size Detection using Time of Flight of Anti-symmetric (Ao) and Mode Converted Ao mode of Guided Lamb WavesJournal of Intelligent Material Systems and Structures, 2010
- Interaction of guided Lamb waves with an asymmetrically located delamination in a laminated composite plateSmart Materials and Structures, 2010
- Interaction of the primary anti-symmetric Lamb mode (Ao) with symmetric delaminations: numerical and experimental studiesSmart Materials and Structures, 2009
- Identification of delamination position in cross-ply laminated composite beams using S0 Lamb modeComposites Science and Technology, 2008
- Group delay measurements using modally selective Lamb wave transducers for detection and sizing of delaminations in compositesSmart Materials and Structures, 2007
- Leaky Lamb waves for the detection and sizing of defects in bonded aluminium lap jointsNDT & E International, 2005
- Delamination detection in smart composite beams using Lamb wavesSmart Materials and Structures, 2004
- The interaction of Lamb waves with delaminations in composite laminatesThe Journal of the Acoustical Society of America, 1993
- Real-time study of frequency dependence of attenuation and velocity of ultrasonic waves during the curing reaction of epoxy resinThe Journal of the Acoustical Society of America, 1986