Pretreatment of polylactic acid (PLA) plastics by UV-C irradiation, biosurfactants and deep eutectic solvent (DES) to enhance biodegradation

Authors:
  • PTPatamavadee Treeson
    Patamavadee Treeson
  • ELEkawan Luepromchai
    Ekawan Luepromchai
  • NKNichakorn Khondee
    Nichakorn Khondee

Abstract
Polylactic acid (PLA) is an interesting alternative to petroleum-based plastic due to its compostability. However, PLA requires around six months to two years to be degraded in conventional compost and natural environment. To enhance the biodegradation of PLA by a bacterial consortium (Nocardiodes zeae EA12, Stenotrophomonas pavanii EA33, Gordonia desulfuricans EA63, and Chitinophaga jiangningesis EA02), this study applied UV-C irradiation and surface coating with biosurfactants and deep eutectic solvent (DES) as pretreatment steps. The PLA film deterioration after UV-C exposure was analyzed by the reduction in viscosity average molecular weight, tensile properties, and ATR-FTIR spectroscopy. The deterioration and hydrophilicity of PLA films increased with an increase in irradiation time. Moreover, the hydrophilicity of the PLA surface was significantly enhanced after surface coating with biosurfactant from Weissella cibaria PN3, which led to more biofilm formation than that on non-coated PLA films. The biodegradability of UV-C irradiated PLA films coated with biosurfactants and DES were later investigated in the liquid medium. The molecular weight of UV-C irradiated PLA films was reduced by 68.1% after 28 days of biodegradation treatments. However, the coated and non-coated PLA films did not show significant difference of weight loss and reduction of Mν. In the liquid phase, the surface coating did not affect the biodegradation because the bacteria could easily contact with the PLA films. The following experiment investigated the effect of UV-C irradiation and DES surface coating in a composting system (i.e. solid phase experiment). DES was selected as a coating material due to its low cost. The result showed that the UV-C irradiated PLA films coated with DES had the highest cumulative CO2 and percent mineralization. This was due to the deterioration of the UV-C irradiation PLA films and the enhanced biofilm formation by DES coating. Thus, the surface coating treatment should be applied to UV-C irradiated PLA films before composting. On the other hand, UV-C irradiation caused the significant deterioration of the PLA films; thus, it might be applied alone as an effective pretreatment in various PLA waste treatment processes.