Peak-Efficiency Detection and Peak-Efficiency Tracking Algorithm for Switched-Mode DC–DC Power Converters
Author:
- 1 December 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 29 (12) , 6555-6568
Abstract
In this paper, the system allowing to detect the peak-efficiency point of the periodically switching MOS power transistor is presented. The use of this system concerns namely the integrated dc-dc converters, charge pumps, class-E amplifiers, or isolated MOSFET power switches. Information about the peak-efficiency point position can be used to modify the power-switch operating conditions, which allows us to obtain the maximal available power-efficiency for a given operating point. The algorithm of the peak-efficiency tracking is developed here on the example of integrated 3.2 MHz step-down (buck) 5-A dc-dc converter. In this example, sizes of NMOS and PMOS power transistors are adjusted “on the fly,” in order to obtain the highest possible efficiency. In particular, power efficiency is optimized for the output current IOUT, battery and output voltages VBAT and VOUT, switching frequency fSW, temperature, and process variations. The principle of the method relies on the balancing of the Joule heat energy dissipated on the resistive elements, and energy dissipated during the charging process of the transistors' driving capacitances. As the result of the peak-efficiency tracking algorithm, the flat efficiency curve is obtained in a wide current range.Keywords
This publication has 13 references indexed in Scilit:
- Efficiency Optimization in Digitally Controlled Flyback DC–DC Converters Over Wide Ranges of Operating ConditionsIEEE Transactions on Power Electronics, 2012
- Efficiency optimization of integrated DC-DC buck converters2010
- Digitally Controlled Low-Power DC-DC Converter with Instantaneous On-Line Efficiency Optimization2009
- Pulse‐Width Modulated DC‐DC Power Converters2008
- Predictive Efficiency Optimization for DC–DC Converters With Highly Dynamic Digital LoadsIEEE Transactions on Power Electronics, 2008
- Output Stages for Integrated DC-DC Converters and Power ICs2007
- Maximum Efficiency Point Tracking (MEPT) Method and Digital Dead Time Control ImplementationIEEE Transactions on Power Electronics, 2006
- Improvement of Light-Load Efficiency Using Width-Switching Scheme for CMOS TransistorsIEEE Power Electronics Letters, 2005
- Synchronous rectification with adaptive timing control2002
- Lossless current sensing in low-voltage high-current DC/DC modular suppliesIEEE Transactions on Industrial Electronics, 2000