The precipitation behavior of an Al–Cu–Mg–Ag alloy under ECAP
Authors:
- M. GazizovMGM. Gazizov
- R. KaibyshevRKR. Kaibyshev
- 1 December 2013
- journal article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 588, 65-75
Abstract
No abstract availableKeywords
This publication has 37 references indexed in Scilit:
- Effect of over-aging on the microstructural evolution in an Al–Cu–Mg–Ag alloy during ECAP at 300°CJournal of Alloys and Compounds, 2012
- On strain-induced dissolution of θ′ and θ particles in Al–Cu binary alloy during equal channel angular pressingMaterials Science and Engineering: A, 2011
- On the origin of the extremely high strength of ultrafine-grained Al alloys produced by severe plastic deformationScripta Materialia, 2010
- Influence of equal-channel angular pressing on precipitation in an Al–Zn–Mg–Cu alloyActa Materialia, 2009
- Principles of equal-channel angular pressing as a processing tool for grain refinementProgress in Materials Science, 2006
- Large enhancement in mechanical properties of the 6061 Al alloys after a single pressing by ECAPScripta Materialia, 2005
- Microstructures and mechanical properties of ultrafine grained 7075 Al alloy processed by ECAP and their evolutions during annealingActa Materialia, 2004
- Microstructure refinement and mechanical properties of severely deformed Al–Mg–Li alloysMaterials Science and Engineering: A, 2002
- Effect of aging treatment on heavily deformed microstructure of a 6061 aluminum alloy after equal channel angular pressingScripta Materialia, 2001
- Microstructure of two-phase Al–1.7 at% Cu alloy deformed by equal-channel angular pressingActa Materialia, 2001