Reducing the Burn Marks on Injection-Molded Parts by External Gas-Assisted Injection Molding
Open Access
Abstract
A burn mark is a sort of serious surface defect on injection-molded parts. In some cases, it can be difficult to reduce the burn marks by traditional methods. In this study, external gas-assisted injection molding (EGAIM) was introduced to reduce the burn marks, as EGAIM has been reported to reduce the holding pressure. The parts with different severities of burn marks were produced by EGAIM and conventional injection molding (CIM) with the same molding parameters but different gas parameters. The burn marks were quantified by an image processing method and the quantitative method was introduced to discuss the influence of the gas parameters on burn marks. The results show that the burn marks can be eliminated by EGAIM without changing the structure of the part or the mold, and the severity of the burn marks changed from 4.98% with CIM to 0% with EGAIM. Additionally, the gas delay time is the most important gas parameter affecting the burn marks.Keywords
Funding Information
- Natural Science Foundation of Zhejiang Province (LY19E050004, LY20E050020)
- Key R & D Program of Zhejiang Province (2021C01086)
- National Natural Science Foundation of China (51875525, 52105282)
This publication has 22 references indexed in Scilit:
- Study on the Online Monitoring of Burn Marks by Gas SensorInternational Journal of Automation Technology, 2017
- Interactive robust optimal design of plastic injection products with minimum weldlinesThe International Journal of Advanced Manufacturing Technology, 2016
- Online quality optimization of the injection molding process via digital image processing and model-free optimizationJournal of Materials Processing Technology, 2015
- Reducing ghost marks in injection-molded plastic parts by using external gas-assisted holding pressureInternational Communications in Heat and Mass Transfer, 2015
- Warpage control of headlight lampshades fabricated using external gas-assisted injection moldingInternational Journal of Heat and Mass Transfer, 2015
- Injection moulding of ultra high aspect ratio nanostructures using coated polymer toolingJournal of Micromechanics and Microengineering, 2014
- Novel approach to the measurement of the visual perceptibility of sink marks on injection molding partsPolymer Testing, 2011
- Influence of injection parameters and mold materials on mechanical properties of ABS in plastic injection moldingInternational Communications in Heat and Mass Transfer, 2010
- Study on the packing effects of external gas‐assisted injection molding on part shrinkage in comparison with conventional injection moldingPolymer Engineering & Science, 2010
- Direct-Search-Based Automatic Minimization of Weldlines in Injection-Molded PartsPolymer-Plastics Technology and Engineering, 1998