Torque Performance Enhancement in Consequent Pole PMSM Based on Magnet Pole Shape Optimization for Direct-Drive EV
- 24 September 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 57 (2) , 1-7
Abstract
Developing a permanent magnet synchronous machine (PMSM) for direct–drive electric vehicle (EV) has challenges such as obtaining high torque density and low torque ripple. The PMSM should have high pole numbers owing to low–speed operation, thereby increasing the use of rare earth magnets and cost. Therefore, in this paper a consequent pole (CP) rotor topology is proposed in which the permanent magnet (PM) volume is reduced when compared with conventional surface PMSM (SPMSM). However, replacing south poles in an SPMSM with induced steel poles can increase torque ripple and reduce torque density. In order to improve torque density in a CP PMSM, structural modifications such as multilayer windings, non-ferromagnetic barriers have been proposed in the literature. These modifications increased the torque density while increasing the torque ripple. Therefore, this paper proposes a novel two-level optimization method based on gradient descent algorithm, to address the challenges of improving torque density and reducing torque ripple simultaneously in a CP PMSM. Initially, an expression for the magnet pole arc angle is derived for CP PMSM based on magnetic equivalent circuit. A two-level optimization is performed on a baseline CP PMSM to determine the optimal magnet pole arc. The torque production and torque ripples of the optimized design are validated by simulation and experimental results.Keywords
This publication has 13 references indexed in Scilit:
- Rotor Design Optimization of a New Flux-Assisted Consequent Pole Spoke-Type Permanent Magnet Torque Motor for Low-Speed ApplicationsIEEE Transactions on Magnetics, 2018
- Suppression of Even-Order Harmonics and Torque Ripple in Outer Rotor Consequent-Pole PM Machine by Multilayer WindingIEEE Transactions on Magnetics, 2018
- Investigation of a less rare-earth permanent-magnet machine with the consequent pole rotorAIP Advances, 2018
- Electromagnetic performance analysis of PMSM with eccentric consequent pole rotor2017
- 2-D Analytical Magnetic Field Prediction for Consequent-Pole Permanent Magnet Synchronous MachinesIEEE Transactions on Magnetics, 2016
- Comparative Analysis of End Effect in Partitioned Stator Flux Reversal Machines Having Surface-Mounted and Consequent Pole Permanent MagnetsIEEE Transactions on Magnetics, 2016
- Design considerations for permanent magnet machine drives for direct-drive electric vehicles2015
- Structure of Concentrated-Flux-Type Interior Permanent-Magnet Synchronous Motors Using Ferrite Permanent MagnetsIEEE Transactions on Magnetics, 2014
- Fractional Slot Concentrated Winding PMSM With Consequent Pole Rotor for a Low-Speed Direct Drive: Reduction of Rare Earth Permanent MagnetIEEE Transactions on Energy Conversion, 2014
- Performance of Low-Cost Permanent Magnet Material in PM Synchronous MachinesIEEE Transactions on Industrial Electronics, 2012