Grain Boundary Pinning by Particles
Authors:
- 12 January 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 638-642, 3907-3912
Abstract
Grain boundary pinning by particles is widely used to prevent grain growth during heat treatment in a variety of commercial alloys. Its practical relevance is matched by a considerable amount of theoretical work that has been devoted this problem. A key issue of boundary pinning is the particle/interface interaction mechanism and its associated pinning force. According to Ashby et al. an interface may interact with a particle in two ways: either it goes through the particles or, more usually, bends round and envelopes the particle. Based on these mechanisms one may derive quantitative expressions relating the characteristics of the particle dispersion and a critical or limiting grain radius. Thus, Zener expression assumes that the interface goes through the particles whereas Rios expression assumes that the interface bends round and envelopes the particle. Both the mechanisms and the resulting expressions are discussed here in detail and compared with available experimental data.Keywords
This publication has 11 references indexed in Scilit:
- Grain curvature measurements: A comparison with geometrical modelsScripta Materialia, 2007
- Geometrical models for grain, grain boundary and grain edge average curvature in an Al-1mass%Mn alloyScripta Materialia, 2005
- Microstructure and mechanical properties of Si and YN doped powder metallurgical tantalumZeitschrift für Metallkunde, 2004
- Grain boundary curvature and particle pinning in an Al–1mass%Mn alloyScripta Materialia, 2004
- Grain boundary pinning by Al6Mn precipitates in an Al–1wt%Mn alloyScripta Materialia, 2004
- An irreversible thermodynamic approach to normal grain growth with a pinning forceMaterials Science and Engineering: A, 2002
- Five Decades of the Zener Equation.ISIJ International, 1998
- On the relationship between pinning force and limiting grain radiusScripta Materialia, 1996
- Relationship between grain Boundary Curvature and Grain SizeMetallurgical Transactions A, 1992
- Overview no. 62Acta Metallurgica, 1987