Biocomposites based on cellulose and starch modified urea‐formaldehyde resin: Hydrolytic, thermal, and radiation stability
- 23 March 2018
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 40 (4) , 1287-1294
Abstract
Two biocomposites based on cellulose (UFC) and starch modified urea formaldehyde (UFS) resin (F/U ratio of 0.8) were synthesized using the same procedure. The hydrolitical, thermal, and radiation stability of biocomposites are determined. Also, released formaldehyde during the acid hydrolysis is determined. Biocomposites based on modified UF resin have been irradiated with (50 kGy). Cellulose modified UF resin after γ‐radiation has 1.38% released formaldehyde; unmodified UF resin has 2.21% released formaldehyde. Thermal stability of biocomposites is determined using nonisothermal thermogravimetric analysis, differential thermal gravimetry (DTG), and differential thermal analysis with IR spectroscopy. Moving the DTG peak to higher temperatures indicates an increased thermal stability of cellulose modified UF resin, which is confirmed by the FTIR analysis. Gamma radiation most often causes a decrease in the intensity of the peaks in the FTIR spectrum. POLYM. COMPOS., 40:1287–1294, 2019. © 2018 Society of Plastics EngineersKeywords
Funding Information
- Ministry of Science and Technological Development of the Republic of Serbia (45022, 45020)
This publication has 43 references indexed in Scilit:
- Thermal degradation of urea‐formaldehyde cellulose composites filled with aluminum particles: Kinetic approach to mechanismsJournal of Applied Polymer Science, 2017
- Effect of silica nanopowder on the properties of wood flour/polymer compositePolymer Engineering & Science, 2012
- Hydrolytic stability of cured urea‐formaldehyde resins modified by additivesJournal of Applied Polymer Science, 2009
- Characterization of highly filled wood flour–PVC composites: Morphological and thermal studiesJournal of Applied Polymer Science, 2009
- Separation of gold(III) ions from copper(II) and zinc(II) ions using thiourea–formaldehyde or urea–formaldehyde chelating resinsJournal of Applied Polymer Science, 2008
- Dynamic mechanical analysis of urea–formaldehyde resin adhesives with different formaldehyde‐to‐urea molar ratiosJournal of Applied Polymer Science, 2008
- Fluorinated polyether additives to improve the performance of urea–formaldehyde adhesives for wood panelsJournal of Applied Polymer Science, 2007
- Effects of formaldehyde to urea mole ratio on thermal curing behavior of urea–formaldehyde resin and properties of particleboardJournal of Applied Polymer Science, 2006
- NMR study of the stabilities of urea–formaldehyde resin components toward hydrolytic treatmentsJournal of Applied Polymer Science, 1994
- Properties of sisal-CNSL compositesJournal of Materials Science, 1992