Undrained Load Capacity of Torpedo Anchors Embedded in Cohesive Soils
- 16 November 2010
- journal article
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- Vol. 133 (2) , 021102
Abstract
This paper presents a numerical based study on the undrained load capacity of a typical torpedo anchor embedded in a purely cohesive isotropic soil using a three-dimensional nonlinear finite element model. In this model, the soil is simulated with solid elements capable of representing its nonlinear physical behavior and the large deformations involved. The torpedo anchor is also modeled with solid elements, and its geometry is represented in detail. Moreover, the anchor-soil interaction is addressed with contact finite elements that allow relative sliding with friction between the surfaces in contact. A number of analyses are conducted in order to understand the response of this type of anchor when different soil undrained shear strengths, load directions, and number and width of flukes are considered. The results obtained indicate two different failure mechanisms: The first one involves significant plastic deformation before collapse and, consequently, mobilizes a great amount of soil; the second is associated with the development of a limited shear zone near the edge of the anchor and mobilizes a small amount of soil. The total contact area of the anchor seems to be an important parameter in the determination of its load capacity, and, consequently, the increase in the undrained shear strength and the number of flukes and/or their width significantly increases the load capacity of the anchor.Keywords
This publication has 17 references indexed in Scilit:
- Setup Following Installation of Dynamic Anchors in Normally Consolidated ClayJournal of Geotechnical and Geoenvironmental Engineering, 2009
- The Development of an FPSO for the Deepwater Gulf of Mexico2007
- Technology Assessment of Deepwater Anchors2004
- Low Cost Anchor System for Flexible Risers in Deep Waters2002
- On enhanced strain methods for small and finite deformations of solidsComputational Mechanics, 1996
- Improved versions of assumed enhanced strain tri-linear elements for 3D finite deformation problemsComputer Methods in Applied Mechanics and Engineering, 1993
- Contact‐impact by the pinball algorithm with penalty and Lagrangian methodsInternational Journal for Numerical Methods in Engineering, 1991
- A class of mixed assumed strain methods and the method of incompatible modesInternational Journal for Numerical Methods in Engineering, 1990
- A single surface contact algorithm for the post-buckling analysis of shell structuresComputer Methods in Applied Mechanics and Engineering, 1990
- The behaviour of anchor plates in clayGéotechnique, 1982