The effect of screw rotating speed on mass flow rate, temperature, viscosity, mooney scorch time anddie swell of cold feed rubber blending prepared by qsm 200 extruder machine
Open Access
- 25 May 2017
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 204 (1) , 012020
Abstract
The effect of screw rotating speed on cold feed rubber blending production were evaluated. The specimens were prepared by using QSM 200 extruding machine with variable screw rotating speed 4, 6, 8, 10, 12, 16 and 20 RPM. The temperature set in the screw and head of the barrel was around 80 °C by using Temperature Controll Unit (TCU), and was set around 70°C in zone 1 and 2. Mooney Viscometer was used to evaluate the viscosity and Mooney Scorch Time of cold rubber blending before and after extruding process. In addition, the dynamic rubber process analyzer was used to evaluate the Die Swell of rubber blending after extruding process. The result indicated that the increase of screw rotating speed has a significant effect to increase the flow rate, temperature and the viscosity of the rubber blending. Otherwise, the Mooney Scorch Time (MST) increases due to the decrease of the screw rotating speed. It does not have a significant effect to the die swell of rubber blending.Keywords
This publication has 7 references indexed in Scilit:
- The effect of melt viscosity on thermal efficiency for single screw extrusion of HDPEChemical Engineering Research and Design, 2014
- Polymer Extrusion2014
- Thermal optimisation of polymer extrusion using in-process monitoring techniquesApplied Thermal Engineering, 2013
- Effects of extrusion conditions on die-swell behavior of polypropylene/diatomite composite meltsPolymer Testing, 2008
- Heating of Extrusion Dies2003
- Introduction2003
- Thermomechanics of Glassy and Crystalline Polymers1992