Water‐Based Bitumen Recovery from Diluent‐Conditioned Oil Sands
- 1 October 2004
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 82 (5) , 978-985
Abstract
Important process development aspects leading to more efficient bitumen recovery from diluent‐conditioned oil sands by water‐based methods are discussed. Bitumen viscosity of 0.5–2 Pa·s is required at the processing temperature and can be reduced to this level by bitumen dilution with an organic solvent. Oil sand porosity, however, poses a restriction on the amount of diluent that can be accepted by the oil sand. Also oil sand‐diluent conditioning time is an important process parameter and can vary from a few minutes for oil sands with low‐viscosity bitumen to several hours if viscosity of the bitumen is high. Additionally, the bitumen separation efficiency during digestion and flotation can be enhanced by reducing the bitumen/water interfacial tension through addition, for example, of tripolyphosphate to the aqueous phase.Keywords
This publication has 13 references indexed in Scilit:
- Temperature Effects From the Conditioning and Flotation of Bitumen From Oil Sands in Terms of Oil Recovery and Physical PropertiesJournal of Canadian Petroleum Technology, 2003
- The influence of interfacial tension in the recovery of bitumen by water-based conditioning and flotation of Athabasca oil sandsFuel Processing Technology, 2003
- Bitumen spreading and formation of thin bitumen films at a water surfaceColloids and Surfaces A: Physicochemical and Engineering Aspects, 1996
- The role of gas bubbles in bitumen release during oil sand digestionFuel, 1995
- Surface and interfacial tension of the Whiterocks bitumen and its relationship to bitumen release from tar sands during hot water processingFuel, 1994
- Tar sand pretreatment with diluentMining, Metallurgy & Exploration, 1993
- Moderate-temperature water-based bitumen recovery from tar sandFuel, 1991
- Comparison of water-based physical separation processes for U.S. tar sandsFuel Processing Technology, 1991
- Tar Sand Research and Development at the University of UtahAnnual Review of Energy, 1987
- Hot water process development for Utah tar sandsFuel Processing Technology, 1982