Flexural Strength, Fracture Toughness, and Hardness of Silicon Carbide and Boron Carbide Armor Ceramics
- 23 February 2010
- journal article
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 7 (5) , 643-651
Abstract
Armor‐grade B 4 C and SiC specimens were analyzed for phase assemblage, microstructure, and mechanical properties. SiC–N showed the highest four‐point fracture strength, and an ∼50% higher notched beam fracture toughness than solid‐state sintered B 4 C and SiC. This was attributed to preferential crack propagation along a weaker amorphous aluminosilicate grain‐boundary interphase, which also attenuated the effect of surface flaws on bending strength. Verco B 4 C showed the highest hardness. That material was phase pure, fully dense, and of finer grain size as compared with pressure‐assisted densification (PAD)‐B 4 C (hot pressed). Verco SiC showed a hardness equal to (Vickers) or higher than (Knoop) PAD‐B 4 C, and a comparatively narrow distribution in measured hardnesses. This was attributed to a fine‐grained, fully dense, solid‐state sintered microstructure with a fine and well‐distributed graphite second phase. Hardness of all specimens decreased with increasing applied load.Keywords
This publication has 18 references indexed in Scilit:
- Density- and Hardness-optimized Pressureless Sintered and Post-hot Isostatic Pressed B4CJournal of Materials Research, 2005
- High‐Toughness Silicon Carbide as ArmorJournal of the American Ceramic Society, 2005
- Improved Ballistic Performance by Using a Polymer Matrix Composite Facing on Boron Carbide Armor Tiles2005
- Recommendations for Determining the Hardness of Armor CeramicsInternational Journal of Applied Ceramic Technology, 2004
- Pressureless Sintering of Boron CarbideJournal of the American Ceramic Society, 2003
- Sintering of Boron Carbide Heat‐Treated with HydrogenJournal of the American Ceramic Society, 2002
- Hardness and Fracture Toughness of Pressureless‐Sintered Boron Carbide (B 4 C)Journal of the American Ceramic Society, 2002
- Additive Effect on Sintering of Boron CarbideJournal of the Ceramic Association, Japan, 1987
- The Effect of Stoichiometry on Mechanical Properties of Boron CarbideJournal of the American Ceramic Society, 1984
- Effect of Boron and Carbon on Sintering of SICJournal of the American Ceramic Society, 1975