FPGA Controlled Pneumatic Variable Valve Actuation
Authors:
- 3 April 2006
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
A control system for pneumatic variable valve actuation has been designed, implemented and tested in a single cylinder test engine with valve actuators provided by Cargine Engineering AB. The design goal for the valve control system was to achieve valve lifts between 2 and 12 mm over an engine speed interval of 300 to 2500 rpm. The control system was developed using LabView and implemented on the PCI 7831. The design goals were fulfilled with some limitations. Due to physical limitations in the actuators, stable operation with valve lifts below 2.6 mm were not possible. During the engine testing the valve lift was limited to 7 mm to guarantee piston clearance. Different valve strategies for residual gas HCCI combustion were generated on a single-cylinder test engine.Keywords
This publication has 4 references indexed in Scilit:
- Variable Valve Actuation for Timing Control of a Homogeneous Charge Compression Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 2005
- Modeling for control of HCCI engines2004
- CSI - Controlled Auto Ignition - the Best Solution for the Fuel Consumption - Versus Emission Trade-Off?SAE International Journal of Advances and Current Practices in Mobility, 2003
- The Knocking Syndrome - Its Cure and Its PotentialSAE International Journal of Advances and Current Practices in Mobility, 1998