Comparison of Model Calculations and Experimental Measurements of the Bulk Cylinder Flow Processes in a Motored PROCO Engine
Authors:
- 1 February 1979
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
A PROCO Flow Simulation (PFSIM) model has been developed to calculate the angular velocity (swirl) and radial velocity (squish) as a function of crank angle for the four strokes of the motored engine cycle. In addition, the PFSIM model calculates the time dependent cylinder pressure, temperature and mass. The model accepts the following swirl-related parameters as input: dimensionless angular momentum and mass flow coefficients for a specific intake and exhaust system configuration. These parameters determine the intake-generated swirl which is computed from the angular momentum flux entering the cylinder during the induction process. An angular momentum flux swirl meter was used to obtain the required input data for three different intake port configurations, and calculations of the bulk cylinder flow were carried out with PFSIM for each intake port configuration. Experimental measurements of in-cylinder swirl were obtained with the spark discharge/time-of-flight method in a motored PROCO research engine for the same three intake ports. Good agreement was found between measured and calculated swirl velocities. The importance of angular momentum dissipation within the cylinder is indicated by the results of this investigation. In further model calculations, the sensitivity of swirl and squish to changes in piston geometry has been shown.Keywords
This publication has 20 references indexed in Scilit:
- Measurements of the Spatial Distribution and Engine Speed Dependence of Turbulent Air Motion in an I.C. EngineSAE International Journal of Advances and Current Practices in Mobility, 1977
- Air Motion in a Four-Stroke Direct Injection Diesel EngineProceedings of the Institution of Mechanical Engineers, 1974
- Measurements of NO Emissions From a Stratified Charge Engine: Comparison of Theory and ExperimentCombustion Science and Technology, 1973
- Nitric Oxide Emissions From Stratified Charge Engines: Prediction and ControlCombustion Science and Technology, 1973
- Wasser und AbwasserEuropean Food Research and Technology, 1970
- Some Contributions to Experimental Combustion ResearchProceedings of the Institution of Mechanical Engineers, Conference Proceedings, 1969
- Air Motion and Fuel Distribution Requirements in High-Speed Direct Injection Diesel EnginesProceedings of the Institution of Mechanical Engineers, Conference Proceedings, 1969
- Paper 4: Induction System Development for High-Performance Direct-Injection Diesel EnginesProceedings of the Institution of Mechanical Engineers, Conference Proceedings, 1965
- Air Swirl in a Road-Vehicle Diesel EngineProceedings of the Institution of Mechanical Engineers: Automobile Division, 1962
- Air Swirl in Oil EnginesProceedings of the Institution of Mechanical Engineers, 1934