Electromagnetic noise mitigation in high-speed printed circuit boards and packaging using electromagnetic band gap structures
Authors:
- S. ShahparniaSSS. Shahparnia
- B. Mohajer-IravaniBMB. Mohajer-Iravani
- O.M. RamahiORO.M. Ramahi
- 28 September 2004
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- Printed circuit board EMI source mechanisms2004
- The radiation of a rectangular power-bus structure at multiple cavity-mode resonancesIEEE Transactions on Electromagnetic Compatibility, 2003
- Suppression of the parallel-plate noise in high-speed circuits using a metallic electromagnetic band-gap structure2003
- An investigation of PCB radiated emissions from simultaneous switching noise2003
- A novel power plane with integrated simultaneous switching noise mitigation capability using high impedance surfaceIEEE Microwave and Wireless Components Letters, 2003
- Reducing power bus impedance at resonance with lossy componentsIEEE Transactions on Advanced Packaging, 2002
- Power-supply decoupling on fully populated high-speed digital PCBsIEEE Transactions on Electromagnetic Compatibility, 2001
- EMI mitigation with multilayer power-bus stacks and via stitching of reference planesIEEE Transactions on Electromagnetic Compatibility, 2001
- Reducing simultaneous switching noise and EMI on ground/power planes by dissipative edge terminationIEEE Transactions on Advanced Packaging, 1999
- Simultaneous Switching Noise of CMOS Devices and Systems1994