Fatigue Crack Propagation Rates for Notched 304 Stainless Steel Specimens In Elevated Temperature Water
Authors:
- 1 August 2004
- journal article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 126 (3) , 318-326
Abstract
Fatigue crack propagation (FCP) rates for 304 stainless steel (304 SS) were determined in 24°C and 288°C air and 288°C water with 20–60 cc H2/kg H2O using double-edged notch (DEN) specimens. Tests performed at matched loading conditions in air and water provided a direct comparison of the relative crack growth rates over a wide range of test conditions. Crack growth rates of 304 SS in water were about 12 times the air rate for both short cracks (0.03–0.25 mm) and long cracks up to 4.06 mm beyond the notch, which are consistent with conventional deep crack tests. The large environmental degradation for 304 SS crack growth is consistent with the strong reduction of fatigue life in high hydrogen water. Further, very similar environmental effects were reported in fatigue crack growth tests in hydrogen water chemistry (HWC). Prior to the recent tests reported by Wire and Mills [1] and Evans and Wire [2], most literature data in high hydrogen water showed only a mild environmental effect for 304 SS, of order 2.5 times air or less. However, the tests were predominantly performed at high cyclic stress intensities or high frequencies where environmental effects are small. The environmental effect in low oxygen environments at low stress intensity depends strongly on both the stress ratio, R, and the load rise time, Tr. Fractographic examinations were performed on specimens tested in both air and water to understand the operative cracking mechanisms associated with environmental effects. In 288°C water, the fracture surfaces were crisply faceted with a crystallographic appearance, and showed striations under high magnification. The cleavage-like facets suggest that hydrogen embrittlement is the primary cause of accelerated cracking.Keywords
This publication has 16 references indexed in Scilit:
- Fatigue Crack Growth Curve for Austenitic Stainless Steels in BWR EnvironmentJournal of Pressure Vessel Technology, 2000
- Fracture Mechanics Parameters for Small Fatigue Cracks1992
- Fatigue crack propagation behaviour of type 316 stainless steel at elevated temperature in a vacuumInternational Journal of Fatigue, 1988
- Corrosion-fatigue crack-growth rates in austenitic stainless steels in light water reactor environmentsInternational Journal of Pressure Vessels and Piping, 1988
- The Benefit of Hydrogen Addition to the Boiling Water Reactor Environment on Stress Corrosion Crack Initiation and Growth in Type 304 Stainless SteelJournal of Engineering Materials and Technology, 1986
- Crack size effects on the chemical driving force for aqueous corrosion fatigueMetallurgical Transactions A, 1985
- THE STRESS INTENSITY FACTOR OF SMALL CRACKS AT NOTCHESFatigue & Fracture of Engineering Materials & Structures, 1982
- A New Parameter for Characterizing Corrosion Fatigue Crack GrowthJournal of Engineering Materials and Technology, 1981
- Fatigue Crack Growth of Stainless Steel Piping in a Pressurized Water Reactor EnvironmentJournal of Pressure Vessel Technology, 1979
- Stress intensity factors of cracks emanating from semi-elliptical side notches in platesInternational Journal of Fracture, 1974