Mono‐ and binuclear nickel catalysts for 1‐hexene polymerization
- 17 April 2018
- journal article
- research article
- Published by Wiley in Applied Organometallic Chemistry
- Vol. 32 (6)
Abstract
Polymerization of 1‐hexene was carried out using a mononuclear (MN) catalyst and two binuclear (BN1 and BN2) α‐diimine Ni‐based catalysts synthesized under controlled conditions. Ethylaluminium sesquichloride (EASC) was used as an efficient activator under various polymerization conditions. The highly active BN2 catalyst (2372 g poly(1‐hexene) (PH) mmol−1 cat) in comparison to BN1 (920 g PH mmol−1 cat) and the MN catalyst (819 g PH mmol−1 cat) resulted in the highest viscosity‐average molecular weight (Mv) of polymer. Moreover, the molecular weight distribution (MWD) of PH obtained using BN2/EASC was slightly broader than those obtained using BN1 and MN (2.46 for BN2 versus 2.30 and 1.96 for BN1 and MN, respectively). These results, along with the highest extent of chain walking for BN2, were attributed to steric, nuclearity and electronic effects of the catalyst structures which could control the catalyst behaviour. Differential scanning calorimetry showed that the glass transition temperatures of polymers were in the range − 58 to −81 °C, and broad melting peaks below and above 0 °C were also observed. In addition, longer α‐olefins (1‐octene and 1‐decene) were polymerized and characterized, for which higher yield, conversion and molecular weight were observed with a narrower MWD. The polymerization parameters such as polymerization time and polymerization temperature showed a significant influence on the productivity of the catalysts and Mv of samples.Keywords
This publication has 72 references indexed in Scilit:
- Bimetallic Coordination Insertion Polymerization of Unprotected Polar Monomers: Copolymerization of Amino Olefins and Ethylene by Dinickel Bisphenoxyiminato CatalystsJournal of the American Chemical Society, 2013
- Methylene-bridged bimetallic α-diimino nickel(ii) complexes: synthesis and high efficiency in ethylene polymerizationDalton Transactions, 2013
- 13C NMR Analysis of α-Olefin Enchainment in Poly(α-olefins) Produced with Nickel and Palladium α-Diimine CatalystsMacromolecules, 2007
- Arene-Bridged Salicylaldimine-Based Binuclear Neutral Nickel(II) Complexes: Synthesis and Ethylene Polymerization ActivitiesOrganometallics, 2007
- Nuclearity and cooperativity effects in binuclear catalysts and cocatalysts for olefin polymerizationProceedings of the National Academy of Sciences, 2006
- Ethylene polymerization with homogeneous nickel–diimine catalysts: effects of catalyst structure and polymerization conditions on catalyst activity and polymer propertiesPolymer, 2004
- Syndiospecific Homopolymerisation of Higher 1-Alkenes with Two Different Bridged[(RPh)2C(Cp)(2,7-tert-BuFlu)]ZrCl2 CatalystsMacromolecular Chemistry and Physics, 2004
- A study of the structure of poly(hexene-1) prepared by nickel(α-diimine)/MAO catalyst using high resolution NMR spectroscopyPolymer, 2004
- Higher ?-olefin polymerizations catalyzed byrac-Me2Si(1-C5H2-2-CH3-4-tBu)2Zr(NMe2)2/Al(iBu)3/[Ph3C][B(C6F5)4]Journal of Polymer Science Part A: Polymer Chemistry, 2000
- Physical-chemical studies of polyhexene-1. Some dilute solution propertiesJournal of Applied Polymer Science, 1973