Design of Continuous Backbone, Cable-Driven Robots
Authors:
- 16 May 2002
- journal article
- Published by Wiley in Journal of Mechanical Design
- Vol. 124 (2) , 265-271
Abstract
Continuous backbone robots driven by cables have many potential applications in dexterous manipulation for manufacturing and space environments. Design of these robots requires specification of a stiff yet bendable backbone, selection of cable support heights and spacings, and development of a cable drive system. The robot arm divides into sections that are subdivided into segments bounded by cable supports. Cable pairs attach to the end of each section and provide two axis bending. Thus, with many sections, the arm can be bent into complex shapes to allow redundant positioning of the end effector payload. The kinematics of the entire arm are determined from the segment kinematics. This paper derives and numerically solves the nonlinear kinematics for a single segment of a continuous backbone robot. Optimal spacing of the cable supports maximizes displacement, load capacity, and simplicity of the robot kinematics. An experimental system verifies the theoretically predicted performance.Keywords
This publication has 9 references indexed in Scilit:
- Continuum robots - a state of the art2003
- Novel Kinematics for Continuum Robots2000
- The NTUA snake: Design, planar kinematics, and motion planningJournal of Robotic Systems, 1999
- A novel 'elephant's trunk' robot1999
- The kinematics of hyper-redundant robot locomotionIEEE Transactions on Robotics and Automation, 1995
- A modal approach to hyper-redundant manipulator kinematicsIEEE Transactions on Robotics and Automation, 1994
- A 'sidewinding' locomotion gait for hyper-redundant robotsAdvanced Robotics, 1994
- Design and motion planning of a mechanical snakeIEEE Transactions on Systems, Man, and Cybernetics, 1993
- Trajectory optimization for kinematically redundant armsJournal of Robotic Systems, 1991