Optimization of Offshore Direct Drive Wind Turbine Generators With Consideration of Permanent Magnet Grade and Temperature
- 2 November 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 34 (2) , 1105-1114
Abstract
In this paper, the main objective is to optimize permanent magnet synchronous generators for offshore direct drive wind turbine, examining the best choice of magnet grades, BHmax, and working temperature. A surface-mounted Nd-Fe-B generator is designed electromagnetically and structurally and optimized for different rated powers of 6, 8, and 10 MW. The results show that the cost of energy decreases as the wind turbine's rated power increases. Further optimizations were carried out using different neodymium magnet grades, and it was found that the higher magnet grades produce a lower cost of energy. In addition, steps were taken to estimate the effect of magnet temperature. A detailed thermal model is used to calculate the cooling airflow requirements to bring the magnet operating temperature from 120 to 80 °C. Allowing the use of cheaper temperature grades of magnets, the additional cooling reduces winding losses and improves the effective BH max of the magnets.Keywords
This publication has 17 references indexed in Scilit:
- Hybrid Cooling Method of Axial-Flux Permanent-Magnet Machines for Vehicle ApplicationsIEEE Transactions on Industrial Electronics, 2015
- Permanent magnet synchronous generator design solution for large direct-drive wind turbines: Thermal behavior of the LC DD-PMSGApplied Thermal Engineering, 2014
- Principles of electrical design of permanent magnet generators for direct drive renewable energy systems2013
- Direct-drive permanent magnet generators for high-power wind turbines: benefits and limiting factorsIET Renewable Power Generation, 2012
- Convection Heat Transfer and Flow Calculations Suitable for Electric Machines Thermal ModelsIEEE Transactions on Industrial Electronics, 2008
- Structural mass in direct-drive permanent magnet electrical generatorsIET Renewable Power Generation, 2008
- Comparison of Direct-Drive and Geared Generator Concepts for Wind TurbinesIEEE Transactions on Energy Conversion, 2006
- Structural analysis of low-speed axial-flux permanent-magnet machinesIEE Proceedings - Electric Power Applications, 2005
- Controlling the properties of high energy density permanent magnetic materials by different processing routesJournal of Physics D: Applied Physics, 2000
- Rare-Earth-Compound Permanent MagnetsJournal of Applied Physics, 1970