Additive manufacturing of three-dimensional (3D) microfluidic-based microelectromechanical systems (MEMS) for acoustofluidic applications
- 6 June 2018
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 18 (14) , 2087-2098
Abstract
Additive manufacturing enables the fabrication of 3D acoustofluidics with microfluidic channels interwoven among 3D acoustic transducer configurations.Keywords
Funding Information
- National Science Foundation (CBET-1650601)
- Institute for Critical Technologies and Applied Science, Virginia Tech
This publication has 57 references indexed in Scilit:
- Torsional and Lateral Resonant Modes of Cantilevers as Biosensors: Alternatives to Bending ModesAnalytical Chemistry, 2012
- On-chip manipulation of single microparticles, cells, and organisms using surface acoustic wavesProceedings of the National Academy of Sciences, 2012
- Monolithic fabrication of millimeter-scale machinesJournal of Micromechanics and Microengineering, 2012
- Integrating stereolithography and direct print technologies for 3D structural electronics fabricationRapid Prototyping Journal, 2012
- Acoustofluidics 8: Applications of acoustophoresis in continuous flow microsystemsLab on a Chip, 2012
- A novel experimental technique for determining node location in resonant mode cantileversJournal of Micromechanics and Microengineering, 2011
- Piezoelectric cantilever sensors with asymmetric anchor exhibit picogram sensitivity in liquidsSensors and Actuators B: Chemical, 2011
- Omnidirectional Printing of Flexible, Stretchable, and Spanning Silver MicroelectrodesScience, 2009
- Exploring the benefits of MEMS for micro assembly tasksAssembly Automation, 2004
- A classification scheme for quantitative analysis of micro‐grip principlesAssembly Automation, 2004