The effect of resin formulation on the cellular morphology and mechanical properties of phenolic foams
Authors:
- 2 August 2019
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 137 (5) , 48331
Abstract
In the present study, the effects of blowing agent concentration, surfactant, and resin viscosity on the cellular structure, density, and compressive strength of phenolic foams were investigated. The mechanism of foaming was studied by thermal analyses, as well. The scanning electron microscopy was performed to investigate the morphology of foams. The presence of surfactant was essential to obtain a foam structure. By increasing the amount of blowing agent in the formulation, the bubbles became larger. The variation of the resin viscosity had the sharp effect on the cell size and its distribution so that the cell size dropped from 108 to 77 μm in the sample with the highest viscosity. The mechanical properties were significantly affected by foam structure as well as the cell uniformity. By decreasing the average cell sizes, the compression strength and modulus were improved up to more than 60%. Finally, the optimum values for viscosity of resin and, blowing agent, and surfactant concentrations were obtained. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020, 137, 48331.Keywords
This publication has 23 references indexed in Scilit:
- Fabrication and mechanical properties of phenolic foam reinforced with graphene oxidePolymer Composites, 2013
- Pulverized polyurethane foam particles reinforced rigid polyurethane foam and phenolic foamJournal of Applied Polymer Science, 2013
- Flame‐retardant and mechanical properties of phenolic foams toughened with polyethylene glycol phosphatesPolymers for Advanced Technologies, 2013
- Formulation optimization of unreinforced and lignin nanoparticle-reinforced phenolic foams using an analysis of variance approachComposites Science and Technology, 2012
- Effects of cell size on quasi-static compressive properties of Mg alloy foamsMaterials & Design (1980-2015), 2012
- Bubble nucleation and growth in polymer solutionsPolymer Engineering & Science, 2004
- Prediction of bubble growth and size distribution in polymer foaming based on a new heterogeneous nucleation modelJournal of Rheology, 2004
- Mechanical characterization of short fiber reinforced phenolic foamComposites Part A: Applied Science and Manufacturing, 2003
- The effect of cell size on the mechanical behavior of cellular materialsActa Metallurgica et Materialia, 1990
- Surfactant Effects in Phenolic Foam ResinsJournal of Cellular Plastics, 1989