Low dielectric loss AlN ceramics fabricated via DLP 3D printing achieving high strength and thermal conductivity through plasticizer and optimized debinding
Authors:
- Dajun XuDXDajun Xu
- Yanwei HuangYHYanwei Huang
- Liang CaiLCLiang Cai
- Biao YiBYBiao Yi
- Yingjie GuoYGYingjie Guo
- Guangfan TanGTGuangfan Tan
- Zhen ShenZSZhen Shen
- Yingchun ZhangYZYingchun Zhang
- 11 September 2026
- journal article
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 47 (3)
Abstract
No abstract availableFunding Information
- National Natural Science Foundation of China (51772022)
This publication has 44 references indexed in Scilit:
- Enhancing rheology and mechanical properties of DLP 3D-printed Si3N4 materials via composition optimization and gas-pressure sinteringInternational Journal of Minerals, Metallurgy and Materials, 2025
- Sintering behaviors, microstructure and properties of CaO–B2O3–SiO2 glass-ceramics for LTCC applicationsCeramics International, 2024
- Efficient carbon dioxide adsorption properties of cellular structure Li4SiO4 sorbents prepared by additive manufacturing based on polymer-derived ceramics strategyChemical Engineering Journal, 2024
- Balancing thermal conductivity and strength of hot-pressed AlN ceramics via pre-sintering and annealing processCeramics International, 2023
- Preparation of large-size alumina ceramic parts by DLP 3D printing using high-solid-loading paste and optimizing the debinding processCeramics International, 2023
- Dielectric properties and thermal conductivity of Si3N4–SiC composite ceramicsJournal of the Korean Ceramic Society, 2022
- Formation mechanism of stereolithography of Si3N4 slurry using silane coupling agent as modifier and dispersantCeramics International, 2020
- Largely enhanced thermal conductivity of poly (ethylene glycol)/boron nitride composite phase change materials for solar-thermal-electric energy conversion and storage with very low content of graphene nanoplateletsChemical Engineering Journal, 2017
- Preparation of a defect-free alumina cutting tool via additive manufacturing based on stereolithography – Optimization of the drying and debinding processesCeramics International, 2016
- The Method of Three-Point Bending in Testing Thin High-Strength Reinforced Plastics at Large DeflectionsMechanics of Composite Materials, 2005