The Application of 40Ti-35Ni-25Nb Filler Foil in Brazing Commercially Pure Titanium
Open Access
Abstract
The clad ternary 40Ti-35Ni-25Nb (wt %) foil has been applied in brazing commercially pure titanium (CP-Ti). The wavelength dispersive spectroscope (WDS) was utilized for quantitative chemical analyses of various phases/structures, and electron back scattered diffraction (EBSD) was used for crystallographic analyses in the brazed joint. The microstructure of brazed joint relies on the Nb and Ni distributions across the joint. For the β-Ti alloyed with high Nb and low Ni contents, the brazed zone (BZ), consisting of the stabilized β-Ti at room temperature. In contrast, eutectoid decomposition of the β-Ti into Ti2Ni and α-Ti is widely observed in the transition zone (TZ) of the joint. Although average shear strengths of joints brazed at different temperatures are approximately the same level, their standard deviations decreased with increasing the brazing temperature. The presence of inherent brittle Ti2Ni intermetallics results in higher standard deviation in shear test. Because the Ni content is lowered in TZ at a higher brazing temperature, the amount of eutectoid is decreased in TZ. The fracture location is changed from TZ into BZ mixed with α and β-Ti.Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (MOST 106-2221-E-002-174-MY3)
This publication has 13 references indexed in Scilit:
- The Joint Strength and Fracture Mechanisms of TC4/TC4 and TA0/TA0 Brazed with Ti-25Cu-15Ni Braze AlloyJournal of Materials Engineering and Performance, 2017
- Composition optimization of low modulus and high-strength TiNb-based alloys for biomedical applicationsJournal of the Mechanical Behavior of Biomedical Materials, 2017
- Evaluation of mechanical and wear properties of Ti xNb 7Fe alloys designed for biomedical applicationsMaterials & Design, 2016
- High strength beta titanium alloys: New design approachMaterials Science and Engineering: A, 2015
- Selective laser melting of in situ titanium–titanium boride composites: Processing, microstructure and mechanical propertiesActa Materialia, 2014
- Manufacture by selective laser melting and mechanical behavior of commercially pure titaniumMaterials Science and Engineering: A, 2014
- Microstructural Observation of Brazed Ti-15-3 Alloy Using the Clad Ti–20Zr–20Cu–20Ni FoilISIJ International, 2013
- Microstructural Evolution of Brazed CP-Ti Using the Clad Ti-20Zr-20Cu-20Ni FoilMetallurgical and Materials Transactions A, 2012
- Strong bonding of infrared brazed α2-Ti3Al and Ti–6Al–4V using Ti–Cu–Ni fillersIntermetallics, 2009
- Specific analysis of EBSD data to study the texture inheritance due to the β → α phase transformationJournal of Materials Science, 2003