Impact of Defect Engineering on High‐Power Devices
Author:
- 20 May 2021
- journal article
- research article
- Published by Wiley in Physica Status Solidi (a)
- Vol. 218 (23) , 2100169
Abstract
Processing of electrical power at megawatt to gigawatt level in the industry, traction, and transmission and distribution requires high‐power devices with a blocking capability up to 10 kV. The mainstream ones require high‐purity silicon wafers with the lowest possible defect content (contamination) and maximal homogeneity of resistivity and thickness. To satisfy current ratings in a typical range of 1–6 kA, single diode or thyristor may occupy nearly the whole 100–150 mm silicon wafer. In addition to the doping profile optimization and gettering in the front‐end processes, the devices are subject to defect engineering to adjust uniformly or locally the recombination lifetime of carriers. In insulated gate bipolar transistors (IGBTs), it is also about dopant activation below 500 °C. Satisfaction of all extremal demands laid on those devices is not possible without the knowledge developed by defect engineering community in the past decades. Some relevant industrial examples of screening the contamination in typical production of silicon high‐power devices are demonstrated as well as the advanced defect engineering methods for increasing device functionality and power density.Keywords
This publication has 12 references indexed in Scilit:
- The Bidirectional Phase Control ThyristorIEEE Transactions on Electron Devices, 2020
- Lifetime control in silicon power P-i-N diode by ion irradiation: Suppression of undesired leakageMicroelectronics Journal, 2006
- Intrinsic Point Defects, Impurities, and Their Diffusion in Silicon2004
- Modeling of transient point defect dynamics in Czochralski silicon crystalsJournal of Crystal Growth, 2001
- Influence of silicon crystal defects and contamination on the electrical behavior of power devicesSolid-State Electronics, 1998
- Accurate simulation of fast ion irradiated power devicesSolid-State Electronics, 1994
- The mechanism of swirl defects formation in siliconJournal of Crystal Growth, 1982
- Deep-level transient spectroscopy: A new method to characterize traps in semiconductorsJournal of Applied Physics, 1974
- Breakdown behavior of rectifiers and thyristors made from striation-free siliconIEEE Transactions on Electron Devices, 1974
- Measurement of Minority Carrier Lifetime and Surface Effects in Junction DevicesProceedings of the IRE, 1955