On contact resistance measurement using four-terminal Kelvin structures in advanced double-polysilicon bipolar transistor processes
Authors:
- S.-L. ZhangSZS.-L. Zhang
- M. OstlingMOM. Ostling
- H. NorstromHNH. Norstrom
- T. ArnborgTAT. Arnborg
- 1 January 1994
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 41 (8) , 1414-1420
Abstract
No abstract availableThis publication has 16 references indexed in Scilit:
- Quantitative correlations between the performance of polysilicon emitter transistors and the evolution of polysilicon/silicon interfacial oxides upon annealingIEEE Transactions on Electron Devices, 1992
- Analysis of Polysilicon Diffusion SourcesJournal of the Electrochemical Society, 1988
- Comparison of experimental and computed results on arsenic- and phosphorus-doped polysilicon emitter bipolar transistorsIEEE Transactions on Electron Devices, 1987
- Modeling and measurement of contact resistancesIEEE Transactions on Electron Devices, 1987
- An investigation of the thermal stability of the interfacial oxide in polycrystalline silicon emitter bipolar transistors by comparing device results with high-resolution electron microscopy observationsJournal of Applied Physics, 1987
- A two-dimensional analytical model of the cross-bridge Kelvin resistorIEEE Electron Device Letters, 1986
- Method for determining the emitter and base series resistances of bipolar transistorsIEEE Transactions on Electron Devices, 1984
- Direct measurements of interfacial contact resistance, end contact resistance, and interfacial contact layer uniformityIEEE Transactions on Electron Devices, 1983
- Bridge and van der Pauw Sheet Resistors for Characterizing the Line Width of Conducting LayersJournal of the Electrochemical Society, 1978
- The electrical properties of polycrystalline silicon filmsJournal of Applied Physics, 1975