Influence of adhesive rough surface contact on microswitches
- 1 December 2009
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 106 (11) , 113502
Abstract
Stiction is a major failure mode in microelectromechanical systems (MEMS). Undesirable stiction, which results from contact between surfaces, threatens the reliability of MEMS severely as it breaks the actuation function of MEMS switches, for example. Although it may be possible to avoid stiction by increasing restoring forces using high spring constants, it follows that the actuation voltage has also to be increased significantly, which reduces the efficiency. In our research, an electrostatic-structural analysis is performed to estimate the proper design range of the equivalent spring constant, which is the main factor of restoring force in MEMS switches. The upper limit of equivalent spring constant is evaluated based on the initial gap width, the dielectric thickness, and the expected actuation voltage. The lower limit is assessed on the value of adhesive forces between the two contacting rough surfaces. The MEMS devices studied here are assumed to work in a dry environment. In these operating conditions only the van der Waals forces have to be considered for adhesion. A statistical model is used to simulate the rough surface, and the Maugis’s model is combined with Kim’s expansion to calculate adhesive forces. In the resulting model, the critical value of the spring stiffness depends on the material and surface properties, such as the elastic modulus, surface energy, and surface roughness. The aim of this research is to propose simple rules for design purposes.Keywords
This publication has 47 references indexed in Scilit:
- Investigation of the electrical contact behaviors in Au-to-Au thin-film contacts for RF MEMS switchesJournal of Micromechanics and Microengineering, 2008
- Advantages of an Energetic Approach to Derive the Electro-Mechanical CouplingSensor Letters, 2008
- Nano- and microscale adhesion energy measurement for Au–Au contacts in microswitch structuresJournal of Applied Physics, 2006
- Asperity interaction in adhesive contact of metallic rough surfacesJournal of Physics D: Applied Physics, 2005
- Control tribological and mechanical properties of MEMS surfaces. Part 1: critical reviewMicrosystem Technologies, 1999
- Accurate method for determining adhesion of cantilever beamsJournal of Applied Physics, 1999
- Adhesion, slip, cohesive zones and energy fluxes for elastic spheres in contactJournal of the Mechanics and Physics of Solids, 1998
- Critical Review: Adhesion in surface micromechanical structuresJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1997
- Fracture testing of bulk silicon microcantilever beams subjected to a side loadJournal of Microelectromechanical Systems, 1996
- Effect of contact deformations on the adhesion of particlesJournal of Colloid and Interface Science, 1975