Friction stir welding of AISI 1080 steel using liquid CO2 for enhanced toughness and ductility
Authors:
- 1 August 2013
- journal article
- research article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 18 (6) , 500-506
Abstract
In this study, FSW of AISI 1080 high carbon (0·85 wt-%) steel was carried out at a temperature below its AC1 under two sets of conditions, one entailing natural cooling and the other rapid cooling with liquid CO2. The joint structures and mechanical properties obtained under both sets of conditions were investigated, whereupon it was found that defect free joints can be successfully fabricated under either. The resulting joint microstructures mainly consisted of grain refined ferrite with some globular cementite. Higher (harder) joint microhardness profiles were obtained under liquid CO2 cooling below AC1 than under natural cooling below AC1. In tensile testing, all joint fractures were observed to occur in the base metal. Also, stir zone tensile strength and toughness were found to be higher in liquid CO2 cooled samples (820 MPa and 76·7 mm N respectively) than in naturally cooled samples. Note that in both cases, the joints were formed at temperatures below AC1.Keywords
This publication has 18 references indexed in Scilit:
- Efficacy of active cooling for controlling residual stresses in friction stir weldsScience and Technology of Welding and Joining, 2010
- Friction stir welding of carbon steelsMaterials Science and Engineering: A, 2006
- Residual stresses in friction stir welded Al sheetsApplied Physics A, 2002
- Strength and ductility of ultrafine grained aluminum and iron produced by ARB and annealingScripta Materialia, 2002
- Ultra-fine grained bulk steel produced by accumulative roll-bonding (ARB) processScripta Materialia, 1999
- Work-Hardening Mechanism during Super-Heavy Plastic Deformation in Mechanically Milled Iron PowderMaterials Transactions, JIM, 1999
- Ultra-fine grained bulk aluminum produced by accumulative roll-bonding (ARB) processScripta Materialia, 1998
- Microhardness measurements and the Hall-Petch relationship in an AlMg alloy with submicrometer grain sizeActa Materialia, 1996
- Structure and properties of ultrafine-grained materials produced by severe plastic deformationMaterials Science and Engineering: A, 1993
- Mechanical properties and structure of extremely strainhardened copperMetals Technology, 1979